User manual MOTOROLA URC 550

[. . . ] Introduction Your universal remote control is simple to program, easy to use, and can operate up to five (5) devices, which include: SAT TV DVD AUDIO AUX Satellite receivers Televisions DVD Audio receivers, amplifiers, CD players nd nd nd VCRs, 2 TV, 2 DVD, 2 Audio device When this happens, replace the existing batteries with two (2) new “AA” batteries to restore normal operation to the remote control. If You Have More Than One Satellite Receiver Your remote control is set at the factory to control all of the functions on your Motorola satellite receiver. However, if you have more than one satellite receiver, you may want to prevent the remote control in one room from affecting the satellite receiver in another room. To prevent this kind of interference, you must "pair" each remote control with each receiver by assigning a new "address" to each combination. [. . . ] Note: Given the size of the code libraries in your remote control, it will take several minutes to cycle through all the codes when using the Point and Press Programming method. Turn on the electronic device (VCR, 2nd TV, 2nd nd DVD, 2 AUDIO) you want to program as an AUXILIARY device. In this order, press and hold the [ENTER] button, then the [MUTE] button. Hold both buttons down together until the mode buttons illuminate in rotation (i. Release both buttons as soon as the mode buttons illuminate. Follow the Code Entry Programming (paragraph 3) or Point and Press Programming® (paragraphs 3 & 4) areas of Section 5 to program your AUX device. Turn on your TV / VCR combination device and set it to its TV mode. Program your remote to operate the TV functions. Using the Code Entry Programming method described in Section 5, find a TV Setup Code that operates the TV functions (Power, Vol / , Mute, Ch / , 0-9) of your TV / VCR unit. Set your combination device to its VCR mode and install a VHS tape. Program your remote to operate the VCR functions. Using the Code Entry Programming method described in Section 5, enter, lock and test each 3-digit VCR Setup Code for your brand until a code is found that operates the transport functions (PLAY, STOP, REW, FWD, PAUSE, REC) of your TV / VCR unit. Before you can test for the correct VCR setup code, you must first press the [VCR] button first to put the remote in its VCR mode. Turn on your TV / DVD combination device and set it to its TV mode. Program your remote to operate the TV functions. Using the Code Entry Programming method described in Section 5, find a TV Setup Code that operates the TV functions (Power, Vol / , Mute, Ch / , 0-9) of your TV / DVD unit. Set your combination device to its DVD mode and install a DVD. Program your remote to operate the DVD functions. Using the Code Entry Programming method described in Section 5, enter, lock and test each 3-digit DVD Setup Code for your brand until a code is found that operates the transport functions (PLAY, STOP, REW, FWD, PAUSE, REC) of your TV / DVD unit. Before you can test for the correct DVD setup code, you must first press the [DVD] button to put the remote in its DVD mode. Last, if you have a TV / VCR / DVD combination unit, you need to program your remote to operate the VCR functions. Set your combination device to its VCR mode and install a VHS tape. [. . . ] To return volume control to your TV, repeat step 1, then press [VOL ], then [TV] in step 2. In the absence of a keypress entry, the mode buttons will stop illuminating after 30 seconds and the remote will exit the programming mode. The Point and Press® (Auto-Scan) Programming method allows you to program your remote control without using codes. Instead, the remote control automatically finds the correct setup code using certain buttons / commands that you select. [. . . ]