User manual MOULINEX CHL 441

[. . . ] - When placing the iron on its stand, ensure that the surface on which the stand is placed is stable. - The power cord must never be close to or in contact with the hot parts of your appliance, close to a source of heat, or resting on a sharp edge. - If the power cord or the plug are damaged do not use the appliance. To avoid any risk these must be replaced by an approved Moulinex service centre (see list in the service booklet). [. . . ] - This appliance must be connected to an earthed socket. Any connection error will invalidate the guarantee. - This apliance is intended solely for domestic and indoor use. - The appliance must not be used if it has fallen, if there is any obvious damage, if there are any leaks or functional anomalies. Never dismantle your appliance: to avoid any danger, take it for inspection to an approved service centre If you have any problems or queries please call our Customer Relations Team first for expert help and advice : HELPLINE 0845 602 1454 - UK (01) 47 51947 - IRELAND or visit our website : www. Steam ironing • FILLING THE WATER TANK : - Unplug your iron before filling it. - Set the steam control on DRY (1) ( ) - Fill the beaker - Open the water tank cover completely (2), set the iron on a flat, stable surface (not when the iron is hot) shown in the diagram (3) and fill the tank. - Do not exceed the “MAX” line indicated on the water tank (with the iron set on its heel). € SETTING THE TEMPERATURE - Set the temperature control shown in the diagram (4) referring to the table below. Wait for the light to go off and come on again before your start ironing (5). FABRICS LINEN COTTON WOOL SILK SYNTHETIC Polyester, Acetate, Acrylic, Nylon POSITION OF THERMOSTAT DIAL MAX ••• •• • • OBTAINING MORE STEAM FOR REMOVING CREASES ( ) (depending on the model) - Press the Shot of steam button (8) - Wait a few seconds between each shot before pressing the button again. - Clean the soleplate (cold iron) with a piece of thick, clean, damp cotton before putting away the iron or before using it again. Recommendation : The self-cleaning function helps to delay the scaling of your iron 9 • CLEANING THE SOLEPLATE - Do not scratch or scrape the soleplate. Do not use strong or abrasive detergents for cleaning. - Clean the soleplate (cold iron) on a piece of thick, clean, damp cotton before putting away the iron. Storing your iron - Unplug it and wait until the soleplate has cooled down. - Empty the water tank and set the steam control on DRY. Problems and possible causes Solutions Problems and possible causes The soleplate is dirty or brown and can stain the linen • You are using too high a temperature • You are using starch • You are using steam while • Wait until the thermostat the iron is not hot enough. € You are using the Shot of • Wait a few seconds betSteam button too often. € The steam flow is too high • Reduce the steam flow. € Your iron has a build-up of scale • Your iron has been used dry for too long. The soleplate is scratched or damaged • You have placed your iron flat on a metallic rest-plate • Do a self-cleaning. [. . . ] Accumulated in the holes of • Clean the soleplate with a the soleplate and are burning non-metallic sponge. € Vacuum the holes of the soleplate from time to time. € Your linen is not rinsed sufficiently or you have ironed a new garment before washing it. € Wash and rinse clothes thoroughly before ironing. [. . . ]