User manual MOULINEX FP 7161

[. . . ] Thank you for choosing a product from the MOULINEX range, exclusively designed for the preparation of foodstuffs. Release button of the cover (a1) and unclipping of the accessory on the upper drive a5. Electronic speed variator from 1 to 5 (depending on model) a6. Storage unit The accessories supplied with the model you have purchased are shown on the label on the top of the packaging. [. . . ] Fit the cover by pressing the middle of it, then clip on the metal pin underneath the hooks (fig. FITTING THE ACCESSORIES Press the release button (a4) to open the upper drive cover (a1). - Place the bowl onto the lower drive (a3). You should hear it click shut Push the seal (k5) as far as possible onto the neck of the jug, then lock the assembled tap (k6 with a quarter turn). Tips : this blender, fitted with its tap, allows you to pour your preparation, directly into glasses (cocktails), onto plates or into bowls (soups) or into the pan (pancakes). Speed 1 helps you to serve thick preparations (milkshakes or smoothies). stop the appliance as soon as it has finished. Clean the assembled tap each time after each use. If you do not need the tap, you can replace it with the stopper (k7) (see fig 6a-1), equipped with the seal (k5). - Place the ingredients in the blender (k3), then lock the lid (k2) onto the jug. - Place the blender assembly (k) onto the upper drive (a2). Tips You can add ingredients via the hole of the cap (k1) during the preparation. Always use your blender (k) with its cover (k2) fitted. - Do not fill the blender with a boiling liquid. - Do not use the blender with dry foodstuffs (walnuts, almonds, peanuts. Speed To remove the blender, hold it by the handle and press the release button (a4). - Grapes, quinces or redcurrants: to obtain better results, clean the filter after every 300g of ingredients. - Important: When the pulp collector is full , stop the appliance , and empty the collector. - Wait until the rotary filter has completely stopped before removing the assembly To remove the centrifugal juice extractor (m5), press the release button (a4), and lift off the assembly. VEGETABLES (depending on model) ACCESSORIES USED Centrifugal juice extractor with pouring spout (m) or Bowl (b3) and centrifugal juice extractor with filter basket (m) FITTING THE ACCESSORIES Spout (m5) Press the release button (a4) to open the upper drive cover (a1). Place the filter (m3) in the centre of the pulp collector (m4), turn and lock the lid (m2) onto the pulp collector (m4). Hold the locking lever (m6) in the closed padlock position then fit the assembly, onto the upper drive (a2). [. . . ] Remark: this accessory is used without a disc or a cutter. USE - Prepare the biscuit dough (you will obtain better results with a soft dough). - Place the nozzle (r2) on the head aligning the two hooks with the two slots on the mincer head. - Place the ring (r1) on the nozzle (r2) then the nut (o6) and tighten fully. [. . . ]