User manual MOULINEX MAESTRO

[. . . ] This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children must be supervised to ensure that they do not play with the appliance. The voltage of your electrical installation must correspond to that of the iron (220V-240V). [. . . ] Your appliance has been designed to function with untreated tap water. However, it is necessary to operate the Self-Clean function regularly in order to eliminate hard water deposits from the steam chamber. If your water is very hard (check with your local water authority), it is possible to mix untreated tap water with storebought distilled or demineralised water in the following proportions : - 50% untreated tap water, - 50% distilled or demineralised water. Heat concentrates the elements contained in water during evaporation. The types of water listed below contain organic waste or mineral elements that can cause spitting, brown staining, or premature wear of the appliance : water from clothes dryers, scented or softened water, water from refrigerators, batteries or air conditioners, pure distilled or demineralised water or rain water should not be used in your Tefal iron. The electronic system cuts off the electric power and the Auto-Stop warning light flashes if the iron is left vertically on its heel for more than 8 minutes, or in a horizontal position for more than 30 seconds. To restart the iron, just move it gently until the warning light stops flashing. The auto-stop light will be lit during normal use!The chosen temperature is too low and does not allow for the formation of steam. You are using steam while the iron is not hot enough. You are using the Shot of Steam button too often. You have stored the iron horizontally, without emptying it and without setting it to . You have removed the anti-scale rod to fill your iron. You are using chemical descaling agents. [. . . ] Your iron has been used dry for too long. Steam or water come from the iron as you finish filling the tank. You have placed your iron flat on a metallic rest-plate or ironed over a zip. [. . . ]