User manual MOULINEX MO2524PA

[. . . ] SAFETY INSTRUCTIONS For your safety, this appliance complies with all applicable standards and regulations (Low Voltage, Electromagnetic Compatibility, Environmental directives, etc. ) • This appliance is not intended to be used by persons (including children) with reduced physical, sensory or mental capacities or lack of experience EN and knowledge, unless they are supervised or have been given instructions beforehand concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure they do not play with the appliance. €¢ This appliance can be used by children provided that they are at least 8 years old, as well as by people lacking experience and knowledge or whose physical, sensorial or mental abilities are reduced, if they have been properly trained and duly informed of the incurred risks. [. . . ] In the horizontal position, place the nozzle (23) in its compartment at the back of the appliance (1b) – fig. €¢ Transport your vacuum cleaner easily thanks to its transport handle (6). CLEANING AND MAINTENANCE Important: Always switch off and unplug your vacuum cleaner before maintenance or cleaning. Warning: remember to stand over a bin every time you clean the dust tray. Remove the dust tray (13) • Withdraw the tube (19) from the vacuum opening (10) - Fig. €¢ Remove the dust tray (13) from its housing (7) : take the tray handle (13a) and remove the tray – fig. EMPTY THE DUST TRAY Important: Empty the dust tray (13) after each use. • Press on the opening lever (13c) – fig. 15a—and then remove the lid – fig. €¢ Make sure that no dust remains inside the tray. €¢ Place the lid back: place the stops in their slots – fig. €¢ Replace the tray (13) in its compartment (7) – Fig. To optimise the performance of your vacuum cleaner, make sure you clean the foam (14a) each time you empty the dust tray (13). €¢ Pull simultaneously on the opening clips (13d) of the HEPA filter case - Fig. €¢ Separate the black foam filter (14a) from the HEPA filter (14b) - Fig. €¢ Wash the black foam filter (14a) under the tap, squeeze it out like a sponge and leave to dry for 12 hours fig. *Depending on model: it means special equipment for some models or optional accessories. 9 903398-01_MO25_city-space-cyclonic_903398/01 11/07/13 09:51 Page10 • Once the foam is completely dry, assemble the HEPA filter case (14): black foam filter (14a) and HEPA filter (14b) under the dust tray (13) – Fig. 22, then replace the dust tray inside its compartment (7) – Fig. The black foam filter (14a) should only be put back into the appliance when it is completely dry. You can use your vacuum cleaner while the black foam filter (14a) is drying by using the replacement black foam filter (14abis). CLEAN THE DUST TRAY (13) AND THE AIR/DUST SEPARATOR (15) Important: Clean the dust tray (13) and the dust separator (15) every month. [. . . ] €¢ If the HEPA filter case (14) (black foam filter (14a) and HEPA filter (14b)) is damaged, throw it in the bin – Fig. 39 - and replace it with a new HEPA filter case (ref. 10 *Depending on model: it means special equipment for some models or optional accessories. 903398-01_MO25_city-space-cyclonic_903398/01 11/07/13 09:51 Page11 • Assemble the HEPA filter case (14): black foam filter (14a) and HEPA filter (14b) under the dust tray (13) – Fig. [. . . ]