User manual MOULINEX MO 4011

[. . . ] In this case, do not open the appliance, but send it to the nearest Approved Service Centre or contact Moulinex Customer Service (see contact particulars on last page). € Make sure that the operating voltage of your vacuum cleaner is the same as your supply voltage - 230-240v. € Unplug the appliance by removing the plug from the power outlet: - immediately after use, - before changing accessories, - before maintenance, cleaning or changing the dustbag. € Do not use the appliance: - if the supply cord is defective. [. . . ] PLUGGING IN THE ELECTRICAL POWER CORD AND USING THE VACUUM CLEANER • Completely unwind the power cord, plug in your vacuum cleaner - fig. CHANGING THE BAG GB I E P SA FA TR • The bag capacity indicator (5) tells you when the bag is full or saturated. If you notice that your vacuum cleaner is less efficient, select the maximum power and by lifting the floor head off the floor. If the indicator remains red, replace the bag. € Open the lid (9) of your vacuum cleaner fig. 14; Unclip the bag (18) by pressing the lever fig. 15, and dispose of the bag in a waste bin - fig. € Fit a fresh bag, position it using the tongue provided and clip it onto the bag support - fig. Slide the bag support back onto the runners - fig. 18 place the bag inside the compartment - fig. € Make sure that the bag is in the correct position before closing the lid (9). 2- The microfilter cassette* • Open the lid (9) of your vacuum cleaner fig. € Withdraw the microfilter cassette* (15) • Separate the grey foam filter (15b) from the microfilter (15a). € Dispose of the microfilter (15a) in a waste bin and replace it with a new Microfilter (ref. € Wash the grey foam filter (15b) with warm soapy water (mild detergent). Squeeze it out and leave it to dry for at least 12 hours. Caution: Make sure that the grey foam filter is completely dry before putting it back in place. € Re-fit the grey foam filter (15b) to the microfilter (15a). € Re-fit the microfilter cassette* in its compartment (15) - fig. € Check that the microfilter cassette* (15) is fitted correctly before re-closing the lid (9). CLEAN THE VACUUM CLEANER • The motor foam-filter protection (12) must always be in place when in use. 20 then remove the foam-filter (12) - fig. [. . . ] gB I E P SA FA TR Mini turbobrush To clean upholstery fabrics in depth. Fit the mini turbobrush to the end of the tube. turbobrush To remove threads and animal hairs ingrained into mats and carpets. Fit the turbobrush to the end of the tube. [. . . ]