User manual MOULINEX PRINCIPIO STEAMIRON

[. . . ] Any intervention apart from cleaning and normal maintenance by the customer must be carried out by an approved Moulinex service centre (see list in the service booklet). - Do not place the appliance, the power cord or the plug in water or in any other liquid. - Do not allow the power cord to hang down within reach of children. [. . . ] · SETTING THE TEMPERATURE - Set the temperature control shown in the diagram (4) referring to the table below. Wait for the light to go off and come on again before your start ironing (5). FABRICS LINEN COTTON WOOL SILK SYNTHETIC Polyester, Acetate, Acrylic, Nylon POSITION OF THERMOSTAT DIAL MAX ··· ·· · · OBTAINING MORE STEAM FOR REMOVING CREASES ( ) (depending on the model) - Press the Shot of steam button (8) - Wait a few seconds between each shot before pressing the button again. 3. - You may start ironing when the thermostat light goes out and comes on again. 4. Unplug your iron and let it cool off before cleaning it. · · SETTING THE STEAM LEVEL (6) In order to avoid water dripping from the iron onto the linen : - Turn off the steam when ironing silk or synthetic fabrics. - Set it at the « low steam » ( ) position for wool. - Set it at the « high steam » ( ) position for cotton or linen. FABRICS LINEN COTTON WOOL SILK SYNTHETIC Polyester, Acetate, Acrylic, Nylon = Steam zone Recommendations : Fabrics and ironing temperatures : · Your iron heats up quickly : begin by ironing those fabrics that are ironed at low temperatures, then go on to those requiring a higher temperature; · If you turn down the thermostat, wait until the thermostat light comes back on before beginning to iron again. · When ironing fabrics with mixed fibres, set the ironing temperature for the most delicate of the fibres. · DAMPENING THE LINEN (SPRAY) ( ) (depending on the model) - When steam or dry ironing, press several times on the Spray Button to moisten the linen (7) and to remove stubborn creases. - Make sure that there is water in the tank before using this button. STEAM SETTING POSITION · CLEAN THE ANTI-CALC VALVE, LOCATED UNDER THE STEAM CONTROL BUTTON (C). (Once per month) - Unplug your iron and empty the water tank. - To remove the anti-calc valve, place the steam control button (C) on and pull the valve upwards. - Soak the valve in a cup of white vinegar or plain lemon juice for 4 hours. - The iron will not function without the anti-calc valve. · USING THE SELF-CLEANING FUNCTION In order to extend the life of your iron, use the SelfCleaning function once per month (do not use descaling agents). - The iron must be cold - Set the steam control button (C) to the dry position. [. . . ] it and without setting it to DRY Brown streaks come through the holes in the soleplate and stain the linen · You are using chemical · Do not add any descaling descaling agents. · You are using the wrong type of water. · Do a self-cleaning and use untreated tap water (see p8). · Do a self-cleaning. · Always set your iron on its heel · Avoid ironing over zips · Fabric fibres have · Do a self-cleaning. [. . . ]