User manual MOULINEX QA417HB1 PASTA

[. . . ] € Slide the lid (b2) over the stainless steel bowl (b1). € Run the appliance for a few seconds on speed "1" and then pour the beaten eggs through the hole in the lid. € Continue on speed "1" for about 30 seconds and then increase to speed 2 for about 1 more minute. SAFETY INSTRUCTIONS • Your fresh pasta kit is designed exclusively for Kitchen machine of QA403 or QB403 type (this code is found on the label under your appliance). [. . . ] € Screw the ring nut (I5) onto the plastic body (I2) in the clockwise direction, without locking it. Do not use the spanner (I8) to lock the nut. € Insert the pasta cutter (I6) in its housing on the left of the plastic body (I2), aligning its lug with the corresponding hole in the plastic body, push it until it locks in place and push it down towards the disc. ž FITTING THE PASTA MAKER ON THE APPLIANCE • Facing the attachment holder (E) outlet, insert the assembled pasta maker inclined to the right, aligning the two bayonets in the pasta maker with the two notches in the attachment. € Push the pasta maker home into the attachment and turn the pasta maker anti-clockwise until it latches with the feed tube in the vertical position. ž USAGE, DISMANTLING AND TIPS • Make sure that the safety cover (a5) is locked correctly (clockwise) on the high-speed outlet (a4). € Place a container to collect the pasta in front of the appliance. € Run the appliance by turning the selector (a1) to speed "4". € Insert a small ball of dough through the feed tube. Wait for the feed screw to be visible before you insert the next dough ball. Never push the dough down the feed tube with your fingers or any other utensil. 2 - ASSEMBLING THE COULIS ATTACHMENT Hold the feed screw (J3) and insert the drive (J2) (spring facing the screw). Insert the assembly into the widest hole in the plastic body (J1). Turn the whole assembly, the screw facing upwards, and fit the filter (J4) aligning the 2 lugs with the 2 notches in the plastic body (J1). Position the ring nut (J5) and screw home. 3 - FITTING THE COULIS ATTACHMENT ON THE APPLIANCE • Facing the attachment holder (E) outlet, insert the assembled coulis attachment (J), with the feed tube in the plastic body (J1) inclined to the right, aligning the two bayonets in the plastic body (J1) with the two notches in the attachment holder. Push the coulis attachment home into the attachment holder and turn the coulis attachment anti-clockwise until Dismantling : • Unlock and dismantle the pasta maker in the reverse order of the assembly. You can use the spanner/pusher (I8) to unscrew the ring nut (I5). Tips : • If the prepared dough is too wet or too sticky to be fed through the pasta maker, just sprinkle it with a little flour to obtain the desired consistency before feeding it through the pasta maker. € On the contrary, if the dough is too dry, add a little beaten egg and mix again before feeding it through the pasta 10 11 NOTICE_PASTA_BOX_0828670-02_PASTA BOX 22/03/12 10:58 Page12 it latches with the feed tube in the vertical position. € Engage the removable collector (J6) on the filter until it reaches a stop. You can adjust the position of the collector (I6) (outlet higher or lower). [. . . ] • To blanch tomatoes , remove stems and wash. Half fill a large pan with water and bring to the boil; turn off the heat. Using a slotted spoon add tomatoes and leave for 30 seconds to 1 minute in the boiling water until the skin begins to split. Remove tomatoes using a slotted spoon and place them in iced water. [. . . ]