User manual MOULINEX SUBITO

[. . . ] - When placing the iron on its stand, ensure that the surface on which the stand is placed is stable. - The power cord must never be close to or in contact with the hot parts of your appliance, close to a source of heat, or resting on a sharp edge. - If the power cord or the plug are damaged do not use the appliance. To avoid any risk these must be replaced by an approved Moulinex service centre (see list in the service booklet). [. . . ] - Allow the iron to cool down before putting it away. 1. Safety instructions - Read the instructions for use carefully before using your appliance for the first time and keep them : any use which does not conform to the instructions for use will absolve Moulinex from any liability. - Do not leave the appliance within reach of children unsupervised. The use of this appliance by children or by disabled persons must be supervised at all times. - Check that the specifications of your appliance are compatible with those of your electrical system. - This appliance must be connected to an earthed socket. Any connection error will invalidate the guarantee. - This apliance is intended solely for domestic and indoor use. - The appliance must not be used if it has fallen, if there is any obvious damage, if there are any leaks or functional anomalies. Never dismantle your appliance: to avoid any danger, take it for inspection to an approved service centre If you have any problems or queries please call our Customer Relations Team first for expert help and advice : HELPLINE 0845 602 1454 - UK (01) 47 51947 - IRELAND or visit our website : www. moulinex. co. uk 8 2. Steam ironing · FILLING THE WATER TANK : - Unplug your iron before filling it. The mixture of water / steam will take with it any residues of scale contained in the soleplate. - Re-set the steam control button (C) to the dry position - Using slow, deliberate movements, tilt the iron from left to right in order to rinse the soleplate thoroughly and to get rid of the remaining water. - Empty the tank - Plug in the iron again to dry the soleplate, which should be done over a cloth (watch out for any splashes of water and steam). - After this operation, unplug the iron again and allow it to cool before cleaning the soleplate. - Clean the soleplate (cold iron) with a piece of thick, clean, damp cotton before putting away the iron or before using it again. Recommendation : The self-cleaning function helps to delay the scaling of your iron 9 · CLEANING THE SOLEPLATE - Do not scratch or scrape the soleplate. Do not use strong or abrasive detergents for cleaning. - Clean the soleplate (cold iron) on a piece of thick, clean, damp cotton before putting away the iron. 5. Storing your iron - Unplug it and wait until the soleplate has cooled down. - Empty the water tank and set the steam control on DRY. Is there a problem ? Problems and possible causes Solutions Problems and possible causes The soleplate is dirty or brown and can stain the linen · You are using too high a temperature · You are using starch · You are using steam while · Wait until the thermostat the iron is not hot enough. [. . . ] The soleplate is scratched or damaged · You have placed your iron flat on a metallic rest-plate Solutions · Clean the soleplate as indicated above. See the temperature table to correctly set the thermostat. · Always spray starch onto the reverse side of the fabric to be ironed. Water drips from the holes in the soleplate · The chosen temperature is · Set the thermostat in the too low and does not allow coloured zone (from ·· to the formation of steam. MAX) · Fill it with tap water. [. . . ]