User manual MOULINEX ZU500A10 INFINYPRESS

[. . . ] Never put fruit stones, excessively hard foods (ice cubes, sugar cubes), extremely fibrous foods, 4 or meat into your juicer. Place one jug (N) under juice exit (J) and the other jug (N) under the dry residue exit (K) (fig. Remember to empty the jug under the residue exit when it is full. [. . . ] Make sure that the spout (I) is in the “low” position (juice flow). The fruit and vegetables must only be inserted while the motor is running. Never use your fingers or other utensils to push food through the spout. Do not press too hard on the pusher (A). Once the ingredients have passed through, let the appliance turn for a few more seconds in order to obtain the maximum amount of juice. We recommend that you do not use the appliance continuously for over 20 minutes. After making your juice, activate the drip-stop system by pushing the spout up before removing the jug to stop the flow of the juice. If the juice contains froth, you can fit the foam separator accessory (O), onto the jug (N) which allows you to keep the froth inside the jug when you pour out the juice into a glass (fig. Practical tips when choosing ingredients: - Choose fruit and vegetables that are best for juicing such as oranges, apples, pears, pineapple, grapes, tomatoes, carrots, celery, cucumber, beetroot . If necessary, use the brush (P), to clean the residue strap (F) (strap inseparable from the filter but you should slide open the silicone cover for cleaning purposes; if necessary, also use the end of the brush (P) to clean this area and then close the silicone cover. The brush can also be used to clean the bowl (G), juice collector (H) with spout with drip-stop (I). 5 Make sure to clean the inside of the screw (C) carefully; if necessary, use the brush (P). Clean the residue exit (K) with a lightly moist and non-abrasive sponge. The pusher (A), the feed tube (B), the bowl (G), the screw (C), the juice collector (H) with the spout with drip-stop (I), the jugs (N), and the foam separator (O) can all go into the dishwasher. If the filters (D/E) are clogged, prewash them with warm water and washing up liquid and use the brush (P). If the filter residue exit is clogged, remove the residues using the other end of the brush (P). Do not clean the juice collector (H), the spout with drip-stop (I), the plastic parts (bowl (G), food presser (A), feed tube (B)) with the abrasive side of the sponge. Tips: To extract the screw (C) from the filter (D/E), turn both pieces together and then press on the screw. [. . . ] WHAT TO DO IF YOUR APPLIANCE DOES NOT WORK PROBLEMS The appliance does not turn on SOLUTIONS - Make sure that all parts are correctly assembled. - Make sure that your appliance is properly plugged in. - Check that the feed tube (B) is correctly locked in position. [. . . ]