User manual MOUNTFIELD EL 390R

[. . . ] Beware of sharp blades: Remove plug from mains before maintenance or if cord is damaged 34. Important: keep the power supply cable away from the blade. Get familiar with the controls and the proper use of the equipment. 2) Only use the lawnmower for the purpose for which it was designed, i. [. . . ] 19) Stop the engine: ­ every time you remove or replace the grass-catcher. ⭠before adjusting the grass cutting height. 20) When mowing, always keep to a safe distance from the rotating blade. 1) Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition. regular maintenance is essential for safety and performance. 2) To reduce the fire hazard, keep the lawnmower, especially the engine, free of grass, leaves, or excessive grease. Do not leave containers with grass cuttings in rooms. 3) Check the stone-guard and grass-catcher frequently for wear and deterioration. 4) Periodically check the electric cables and replace them if they are damaged or if the insulation has been damaged. Never touch a badly insulated cable if it still connected to the power supply. Remove the cable from the socket before taking any action. 5) Wear strong work gloves when removing and reassembling the blade. For safety reasons, these jobs are best carried out at a specialized centre. 7) For reasons of safety, do not use the equipment with worn cables or damaged parts. Parts are to be replaced and not repaired. Use genuine spare parts (blades should always bear the symbol ). Parts that are not of the same quality can damage the equipment and be dangerous for your safety. 1) Mow only in daylight or good artificial light. While cutting, the cable should always be pulled behind the lawnmower and always from the area of grass already cut. Use the cable clamp as described in this manual to prevent the cable from disconnecting by accident. Ensure that it is properly inserted without forcing into the power socket. 4) Never pull the lawnmower by its power cable or pull the cable to remove the plug. [. . . ] The engine automatically stops when the lever (1) is released. 1 All operations on the blade should be carried out at a specialized centre. Note for specialized centres: Reassemble the blade (2) as shown in the drawing and tighten the central screw (1) using a torque wrench set to 16-20 Nm. 2 Do not use forced water and avoid wetting the motor or the electrical components. [. . . ]