User manual MOUNTZ TSC (CAM-OVER WRENCH)

[. . . ] TSC (Cam-Over Wrench) Operating Instructions Rev 1. 0 Calibrating Torque Wrenches To calibrate torque wrenches either use a torque analyzer or torque transducer within the range of the torque wrench. For cam-over torque wrenches calibrate torque in "Peak" mode with an analyzer or transducer. [. . . ] If readings are not within the specification tolerance, then perform calibration adjustments as described below. Recalibrate torque wrench at prescribed intervals. Note: Refer to ISO6789 International Standard for more information on hand tool testing requirements. Torque Adjustment Knob Calibration Adjustments 1. Make scale adjustments, if required, as described in steps 2 - 5. If wrench is nonlinear, contact Mountz for technical repair service. Remove set screw and locking knob at end of handle 3. Peel back rubber grip and loosen 3 set screws to remove handle adjusting sleeve. Turn exposed torque adjustment screw CW to increase torque and CCW to decrease torque to proper setting. Test tool on torque analyzer to ensure correct adjustment to 20% setting was made. Replace adjusting sleeve onto tool ensuring to align zero micrometer scale. Lock 3 set screws, replace locking knob and tighten set screw. Replace rubber grip. Setting and Applying Torque 1. [. . . ] The wrench will automatically reset itself for the next application. With its unique cam-over design, it's impossible to over tighten beyond the preset load. 800-456-1828 Fax: 408-292-2214 mountzsales@mountztorque. com www. etorque. com ISO 9001 Corporate Headquarters: 1080 North 11th Street, San Jose, CA 95112 www. etorque. com Phone: (408) 292-2214 Fax: (408) 292-2733 [. . . ]