User manual MPMAN DAB320

[. . . ] Store your CD in a cool area to avoid damage from heat. The mains plug is used as the disconnect device and it must remain readily operable. To completely disconnect the power input, the mains plug of the apparatus must be disconnected from the mains. the normal function of the product may be disturbed by Strong Electro Magnetic Interference. [. . . ] To activate the auto scan modes, first press the MENU button to enter into the Tune Select Menu, then press the SCROLL or button to select "Local scan" or "Full scan", finally press the SELECT button to confirm, the display will show "Scanning . All the stations that have been found will be stored automatically, to explore the found stations, press the SCROLL or buttons; and when you find a station that you would like to listen to, press the SELECT button To select manual tune, first press the MENU button to enter into the Tune Select Menu, then press the SCROLL or buttons to select "Manual tune", finally press the SELECT button to confirm. Press the SCROLL or buttons to move through the DAB channels, the display will show "5A to 13F" and their associated frequencies. DAB secondary services On some occasions you will see a ">" symbol directly after the name of the station, this indicates that there are secondary services available to that station. The secondary services are inserted directly after the primary station. DAB display modes Every time you press the DISPLAY/INFO button, the display will cycle through the following display modes: DLS DLS stands for Dynamic Label Segment which is a scrolling message that the broadcaster may include in their transmissions. Signal strength The display will show a slide bar to indicate the signal strength, the stronger the signal, the longer the bar will be from left to right. Ensemble/Multiplex (Group name) The Ensemble/Multiplex is a collection of radio stations that are bundled and transmitted together in a single frequency. There are national and local multiplexes, local ones contain stations that are specific to that area. Note: Press and hold the DISPLAY/INFO button for longer than 2 seconds, the software version number will be displayed. To activate auto search, press and hold the I or I buttons until it starts to scan down or up the frequency band, it will stop automatically once a station has been found. Note: The radio will automatically switch between stereo and mono mode, but you can override this and switch this function manually which is helpful for poor signal reception. STORING AND RECALLING PRESET STATIONS In either DAB or FM, you can store up to 10 stations to the favourite presets; this will enable you to get direct access to your favourite stations. To store a preset, first tune to your desired station, then press and hold the PROGRAM button until the display shows the preset number and flash. Finally press the PROGRAM button to confirm your selection, the display will show "Preset # stored". To recall a preset station that you have stored, press the PRESET +/- buttons, the display will show the preset number and the associated information. It would tune to the station in one second after the buttons are released. FACTORY RESET When you move the system to another part of the country, your pre-tuned and stored DAB stations may no longer be available. If this is the case then you will need to reset your system back to its original factory settings; to perform a factory reset, please do the following: 1. Connect the unit to mains and press the STANDBY/ON button once to turn the unit on. Ensure the unit is in DAB mode, then press and hold the MENU button until the display shows "Press SELECT to confirm reset". Release the MENU button and press the SELECT button once, the display will show "Restarting. [. . . ] Repeat program play You may use the program play and the repeat play features together to continuously repeat a programmed playback. First program the desired playback sequence, then press the REPEAT button to select repeating the current track or the entire programmed sequence. TIMER FUNCTION You can set the timer to switch on the system at your desired time, listening mode and volume level. To set the timer, press and hold the TIMER button until the display shows "Timer Set" and the "hour" digit of the timer clock in the display will flash. [. . . ]