User manual MPMAN FRA 200

[. . . ] Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. [. . . ] Then, the `MINUTE` LED indicator will flash and then press the Time Set `Up` or Time Set `Down` button for minute adjustment. Press the C-ADJ Button again to confirm the clock time. Then, the `WEEK DAY` LED indicator `d1` will flash then press the Time Set `Up` or Time Set `Down` button for week day adjustment. (`d1` means Monday and `d7` means Sunday) 5. Press the C-ADJ Button to confirm the Weekday set. Time/Radio Frequency Indicator FM Dot Indicator Standby Indicator PM Indicator MW Band Indicator FM Band Indicator Listening to Radio HOUR Indicator MINUTE Indicator Tuner Information This system features a normal MW/FM analog tuning system. It does not automatically lock in on the exact frequency of a station. However instead of a dial scale and a moving dial pointer we have included a digital frequency display to help you tune more accurately. Do not be concerned If you cannot easily tune the display to the exact frequency of your favourite stations, especially on the MW band. Slowly rotate the TUNING control until the display approaches the frequency of the desired station and stop when get the strongest, noise free reception-even if the display is not indicating the exact frequency of desired station. Battery Backup Installation Memory Backup To insert 1. 5V x 2, R03S/ AAA or equivalent batteries in the battery compartment at the bottom of the unit. It is used to backup the memory of the main CPU. Note: You should replace the battery every six months, or after any extended power outage that could drain the battery power. Radio Operation Press the POWER / ALARM RESET button on the unit to switch the unit ON. The LED Clock Display will show the Radio frequency. Press the BAND button to select the MW or FM. (MW/FM LED indicator will appear on the display. ) 3. Select the desired wave band range with the TUNING CONTROL knob. The display will show the exact frequency of desired station. After 10 seconds, the display will go back to Real Time Clock. 6 5 Listening to Radio ANTENNA FM For FM reception there is a built-in FM antenna wire at the rear of the unit. [. . . ] Then, press the ALARM 1 or ALARM 2 button till the ALARM indicators light off. Alarm non-active - press the ALARM 1 or ALARM 2 button till the ALARM indicators light off. Weekend Sleep function When the Alarm is under non-active mode, Press the SNOOZE/ WEEKEND BUTTON to enable /disable weekend sleep function. If weekend sleep function is on, alarm will not function on SAT and SUNDAY even though the alarm timer is enabled and the time is matched. Display Mode setting Press the DISPLAY button changing the display as shown below. [. . . ]