User manual MPMAN XR-DV30

[. . . ] USER'S MANUAL DVD MICRO SYSTEM XR-DV30 Please read this User Manual carefully before using this product and keep this manual for future reference. IMPORTANT ­ SAFETY INFORMATION 1. Read Instructions All the safety and operating instructions should be read before the product is operated. Retain Instructions The safety and operating instructions should be retained for future reference. Heed Warnings All warnings on the product and in the operating instructions should be adhered to. [. . . ] 2) Connect the two wires from the AM loop antenna to the AM antenna connector on the back panel. Press down the thumb levers to insert each wire, and then release the thumb levers to lock the wires in place. - To prevent noise pickup, keep the AM loop antenna away from the system and other components. 5 ­ Connect FM Wire Antenna 1) Connect the supplied FM wire antenna to the FM antenna connector on the back panel. 2) Be sure to fully extend the FM wire antenna. Make use of the small loop at the free end of the antenna to maintain its position. 3) If noise or interference occurs, use an external antenna with a 75 ohm coaxial cable (not included). Outdoor AM antenna EN-10 CONNECTING DEVICES Coaxial Cable (75 ohm) Coaxial Cable (75 ohm) Outdoor FM antenna 6 ­ Connect External Audio The back panel of the DVD system provides. 1 AUX IN Connect to an external stereo audio input. 2 Line Out Connect to the inputs of external Audio System. 3 COAXIAL Out Connect to an external audio decoder. EN-11 CONNECTING POWER SUPPLY POWER Before plugging the power cord into the AC outlet, check to make sure all of the connections have been properly completed. When they have been, carefully plug power cord into outlet. Press the POWER button on the front panel to power the unit. When the unit is initially powered, a brief surge of electricity may cause interference with other electronic equipment on the same circuit. If this occurs, connect the unit to an outlet on a different circuit. EN-12 BASIC DVD OPERATION Chapter 1 Basic Operation 1. Turn On the TV and Your DVD Receiver Press the Power button on the player or the remote controller, and "Read" appears on the TV screen. If there hasn't a disc in the DVD player, "No disc" will be displayed on both the screen and the VFD. 2. Place A Disc Press the Open/Close button on the remote controller or the front of the DVD player, and "Open" appears on the screen. Then place a disc gently into the tray with the disc's label facing up (double-sided discs have content on both sides, so you can place either side up), and press the Open/Close button again to close the disc tray. "Close" appears and the player stars to read. Then the disc starts playing automatically. (Note: Of some certain type discs, after reading out the type, the Play or Enter button should be pressed to start playing. ) 3. Play The contents of each disc menu vary according to how the disc was authored and what features are included. [. . . ] SPDIF/RAW: Choose this setting if your DVD player is connected to a power amplifier with a coaxial cable or an optical cable; SPDIF/PCM: Choose this setting if your DVD player is connected to a 2-channel digital stereo amplifier; DOWN SAMPLE When playing LPCM format file and connecting the DVD to the Power Magnify System through Coaxial connector, you have to adjust the audio frequency sampling rate to output the best audio effect. EN-26 VIDEO SETUP 4) VIDEO SETUP SCREEN SAVER If the screen saver is on, when your DVD player is I Stop, Open or No Disc state, or there is a frame frozen for more than 60 sec, the screen aver will be displayed. This feature can protect the screen from damage. ON: Choose this setting to activate the screen saver. OFF: Choose this setting to cancel the screen saver. [. . . ]