User manual MPMAN XRM 34

[. . . ] Do not place the product on top of another that may cause overheating (for example, a receiver or amplifier). Do not place anything underneath the product (for example, CDs or magazines). Proper ventilation Place the product in a sufficiently­aerated place to avoid overheating. Allow at least 10cm spacing at the back and top of the product, and 5cm spacing on both sides to prevent overheating. Do not place items such as newspapers, tablecloth, curtains, in front of the ventilating openings. [. . . ] FUNCTION COMPATIBLE WITH AUDIO CD/CD-R(W)MP3/CD-R(W)WMA DIGITAL DISPLAY MATCHED TWO SPEAKERS TOTAL OUTPUT POWER : 2 X 8W RMS DIGITAL PLL FM TUNER USB READER FUNCTION LIST OF MAIN PARTS Master Unit 2 Speakers Remote Control Manual LOCATION OF CONTROLS 4 1POWER ON/OFF 2CD/FM 3USB 4PLAY/PAUSE(AUTO) 5OPEN/CLOSE 6CD DOOR 7VOL ADJUST 8USB 9REMOTE CONTROL SENSOR 10DISPLAY 11EARPHONE JACK 12Amplifier Output 13FM antenna 1. 21. Standby Number key Mute Random Back/Forward CD/FM BASS AUTO TREBLE Open/Close EQ Program Repeat CH+/SEEK+/Next / Prev CD/USB Vol+/Save ST/MO INTRO 6 INSTALL THE REMOTE CONTROL BATTERY 1. Install 2pc ``AAA`` battery into the battery bracket (batteries not provided). Make sure that the + symbol is respected 3. If the batteries leak, clean the battery compartment with a cloth. If chemicals touch you skin, wash immediately. If the remote control is not going to be used for an extended period of time, remove the batteries. Dispose of used battery by following your local hazardous waste regulations. SYSTEM CONNECTION You can connect the player to the speakers and enjoy listening. Connect the speaker cables to the SPEAKER jacks which on the back of the player. BASIC OPERATION PREPARATIVE 1). Before turning on, check whether all the connection are correct and reliable. Press POWER button on the front panel to turn on. It could exist automatically Note: Some disc content is unsuitable for this EQ format, it may arouse distortion while selecting. 8 BASS/TREBLE In play status, press the BASS and TREBLE button on the remote control , and then press VOL-/+ to adjust the BASS and TREBLE value. This function provides a better quality of BASS and TREBLE sound. PLAYING USB Press the "CD/USB" button to switch to CD / USB playback. NOTE: If in FM mode , please press CD/FM first to switch to CD mode before switch to USB Connecting a USB device 1) Insert a USB key inside the connector. Remark: Depending on the capacity of the device, the reading can take more than 1 minute. Once you have plugged your device to the unit, you may need to switch on the USB device before it can operate. This unit does not support a direct USB connection with a computer. You need to use a USB device, a MP3 player or a PMP (Portable Multimedia Player with hard disk). If you are using a USB external hard disk: you need to connect your device simultaneously to an external power source and to the unit. If you are using a self-powered PMP, make sure that the battery is sufficiently loaded. Check that the files system of your USB device is formatted into the FAT or FAT 32 format. USB device formatted into NTFS are not compatible with this unit. [. . . ] Press the button again to stop searching. Soundtrack Selection Press the MO/ST button on the remote control, you may select Mono and Stereo soundtrack output in FM status. If the signal is not strong enough, you cannot select Stereo. Exit FM Status Press the CD/FM button on the remote control (or front panel) to exit FM status, and press CD/USB switch to other modes. [. . . ]