User manual MR COFFEE ECM22

[. . . ] Precautions should always be followed when using electrical appliances, including the following: 1. Scalding may occur if the lid is removed during brewing cycles. To protect against electric shock, do not immerse the power cord, power plug or coffeemaker in water or in any other liquid. Close adult supervision is necessary when this appliance is used by or near children. [. . . ] Make sure the brew basket spout is nestled inside the center opening of the carafe lid. Make sure the power switch is in the Off position. Plug the power cord into an electrical outlet and turn the power switch on, which begins the brewing process. The light will illuminate to let you know that the machine is on. Espresso will begin to flow into the carafe in about 3 ­ 5 minutes. When the espresso stops flowing into the carafe, turn the power switch to the Off position. Unplug the power cord and allow the machine to cool. Do not remove reservoir cap or brew basket until the pressure in the machine has been released. follow procedures in section marked CauTIOn: Pressure on Page 3. Appliance is under pressure or until the appliance has cooled down. Follow the procedures marked CauTIOn: Pressure on Page 3 to relieve the pressure before removing the reservoir cap or brew basket. After the machine has cooled down and all pressure has been relieved, remove the brew basket. Using the filter retainer clip to secure the filter in the brew basket, turn the brew basket upside down to empty. For your convenience and storage, this appliance has a swinging frothing aid. To use the frother, simply swing the aid away or out of the machine. You are now ready to froth and steam your milk. hold the pitcher under the frothing tube so that the frothing aid is slightly immersed in the milk. Turn the power switch slowly to the position. Gently move the pitcher in a circular motion around the steam nozzle for about 45 seconds. ReMeMBer: The milk and the pitcher should be cold prior to frothing. When the milk has doubled in volume, or, if you are using a beverage thermometer, when the milk has reached 100°F insert the frothing aid deeper into the milk to further heat the milk. The temperature of the milk, when finished, should be 140°F 145°F. [. . . ] This warranty does not cover normal wear of parts or damage resulting from any of the following: negligent use or misuse of the product, use on improper voltage or current, use contrary to the operating instructions, disassembly, repair or alteration by anyone other than JCS or an authorized JCS service center. Further, the warranty does not cover: Acts of God, such as fire, flood, hurricanes and tornadoes. what are the limits on JCS's Liability?JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or statutory warranty or condition. [. . . ]