User manual MR COFFEE FTX21

[. . . ] Turn the coffeemaker OFF and unplug the power cord from the power source when the coffeemaker and clock are not in use and before cleaning. Allow the coffeemaker parts to cool before putting on or taking off parts and before cleaning the appliance. Do not operate any appliance with a damaged power cord or power plug, or operate it after the appliance malfunctions, or has been damaged in any manner. Return this appliance only to the nearest Authorized Service Center for examination, repair or adjustment. [. . . ] DO NOT hold back apply pressure Filter Retainer Clip when turning Filter into the Lock position. DO NOT remove the Filter Holder at any time during the brewing process or until pressure is relieved. DO NOT overfill the Filter with ground coffee, as this will cause an improper lock of the Filter Holder, which could result in leaking and damage the seal. DO NOT leave excess coffee grounds on the edge of the Filter Holder (Figure 1). Excess grounds on the edge will cause improper lock which could result in leaking and damage to the seal. DO NOT touch metal parts of Filter Holder until unit has cooled. Metal parts may still be hot immediately after brewing. DO NOT leave water in the Water Reservoir between uses. This can cause improper lock which could result in leaking and damage to the seal. Espresso is a rich, dark coffee served in 2-ounce shots. An espresso made just right is a blend of full-bodied coffee taste and aromatic enjoyment. Move Pitcher in circular motion keeping Frothing Aid just off the bottom of the pitcher. Then begin to lower pitcher so the tip of the Frothing Aid stays just below the milk's surface. Move the pitcher in a circular motion until desired amount of froth is reached. Pour equal parts of espresso coffee and milk. Hold froth back with a spoon while pouring your milk, then spoon the froth into the cup. (Figure 6) TO CLEAN: To clean Frothing Aid and release the pressure, hold a pitcher with a small amount of water under the Frothing Aid slowly turn the Control Knob to the STEAM position and release the steam. When the Frothing Aid stops releasing steam, turn the Control Knob to the "OFF" position and unplug the power cord. Ingredients and Measuring Guide Serving Size 1 cup 2 cups Fine Espresso Ground Coffee 2 cup mark on Filter 4 cup mark on Filter water (Cold) 2 oz. Fill to top of Metal band of Glass Carafe Milk (Skim or 2% froths more easily) 4 oz. Make sure to use the Filter Retainer Clip when discarding the grounds. The metal parts of the Filter Holder might still be very hot. [. . . ] When vinegar reaches the 2 cup mark on the Glass Carafe, place a cup with cold water under the Frothing Aid. Insert the Frothing Arm into the water and slowly turn the control knob to the STEAM position. Repeat Steps 1 ­ 7 as necessary using only tap water to rinse any remaining traces of vinegar out of the appliance. Allow unit to cool for 30 minutes between each rinse cycle. [. . . ]