User manual MR HANDSFREE BLUE-CHAMELEON

[. . . ] You will hear a series of 4 tones (from high to low) and the blue indicator (4) of the headset turns off. You are required to pair the Blue Chameleon headset with your mobile phone once before using it. Each Blue Chameleon headset has a default PIN-code 0000 for pairing, which is stored in its internal memory. You are usually required to enter the PIN-code 0000 in a pairing process with a Bluetooth® mobile phone or other devices; however it depends on the kind of Bluetooth® device that the headset is connected to. [. . . ] Once the Blue Chameleon headset is successfully paired with your mobile phone, you can use it to make and receive calls. The Blue Chameleon headset can be used with voice dialing if your mobile phone supports this feature. Press the MF-button (3), wait for a beep and say the name of the person you want to call. Using the phone keys to make a call: Enter and dial the number on the mobile phone as you normally do. Sound will be transmitted to your headset automatically. Once the call has been set up, the Press and hold the MF-button (3) for 3 seconds to redial the last number you called. When the Blue Chameleon headset is turned on and there is an incoming call, you will hear a musical tone and the blue indicator (4) will change to a quick-flashing mode. Press the MF-button (3) to answer the call or press and hold the MF-button (3) for 3 seconds to reject the call. When the headset is turned off, press and hold the MF-button (3) for 3 seconds to turn the headset on. Note: Due to the different design of some mobile phones, an auto-disconnect may happen even when the Blue Chameleon headset is turned on. In that case, the headset won't ring when there is an incoming call. To reconnect the headset with your mobile phone for an incoming call. Mute function, press the Volume-button (2/8) once again until you hear a beep. Press and hold the MF-button (3) until you hear a series of 4 tones (from high to low) to transfer the call to the mobile phone while talking on the headset. If you want to transfer the call back to the headset, press the MF-button (3) again for 3 seconds. Press and hold the MF-button (3) for 3 seconds to switch to a second call during a call. This function only works when your mobile phone service provider provides this service (check with your network provider). To put a call on hold: Press and hold the MF-button (3) for 3 seconds to put a call on hold. Again for 3 seconds to continue the conversation. Press and hold this button (3) once You are allowed to connect the Blue Chameleon headset with a Bluetooth® enabled PC or PDA that is supported with Audio Gateway Profiles. You hear 5 quick beeps, repeated every 20 seconds. No sound contact between the Blue Chameleon headset and other devices. [. . . ] - Whether it is in the operative range (10 m). The headset will automatically try to reconnect within 90 seconds. The Blue Chameleon headset is turned The blue LED indicator flashes in Standby-mode every 5 seconds. If after 5 minutes no action is taken, the blue LED indicator will on and is paired, but the blue LED indicator doesn't light up. [. . . ]