User manual MR HANDSFREE BLUE VISION 2

[. . . ] Open the battery cover (25) and take out the insulation film (23). Please make sure that the infrared transmitter (26) and the receiver (12) are directed towards each other during operation. The battery is charged preliminary, but nevertheless we recommend charging it before using the carkit for the first time. Plug the adapter jack into the charging socket (9) and the cigarette plug into the cigarette lighter. [. . . ] Note: For all mobile phone types, it is recommended to set "Trust" or "Authorized" for Blue Vision II in the Bluetooth® menu of your mobile phone. Please refer to the manual of your mobile phone for more detailed information. You can disconnect the carkit from your phone when, for example, you want to use another Bluetooth® device with your phone. The Blue Vision II can be disconnected in the following ways: 1. Move the phone more than 10 meters away from the carkit. Before using the mr Handsfree Blue Vision II make sure that: · When no call is in progress, press the Talk button (5) or the Talk button (14) on the remote control once. You will hear a tone that indicates that you can say the desired name ("voice tag"). The phone plays the voice tag and dials the related phone number. You can also activate voice dialing with your phone. For details on voice dialing, please refer to your phone's user's manual. Please note that the voice dialing function is only available if it is supported by your mobile phone. Press the keypad buttons to compose the number (for "+", you should press and hold the * button until you hear a confirmation beep). Speed dialing allows you to set a single-digit number for the telephone numbers you call most. You only have to select the speed dial number to dial the corresponding telephone number. The Blue Vision II can store up to 10 speed dial numbers. Programming speed dial numbers Press and hold the "OK" button (19) on the remote control for 2 seconds until you hear a double beep tone. Press a button from "0" to "9" to select the memory location where you would like to store the telephone number. Enter the telephone number using the digital keypad. Press the "OK" button (19) to confirm the number or press the Reject button (15) if you don't want to save the number. The telephone number you have entered will now correspond to the selected speed dial number. note: · You can write the names for the recorded speed dial numbers on the back side of the remote control where the corresponding memo card (21) is provided. ⷠIf you want to replace a programmed telephone number in the speed dial memory, you should follow the same steps as described above to overwrite the number by a new telephone number. [. . . ] The suggestions below will help you to fulfill any warranty obligations and to enjoy this product for many years. High temperatures can shorten the life of electronic devices and warp or melt certain plastics. ⷠDo not store the carkit in cold areas. When it warms up (to its normal temperature), moisture can form inside, which may damage the electronic circuitry boards. [. . . ]