User manual MSI 760GM-P23

[. . . ] X) Mainboard G52-76991X1  Copyright Notice The material in this document is the intellectual property of MICRO-STAR INTERNATIONAL. We take every care in the preparation of this document, but no guarantee is given as to the correctness of its contents. Our products are under continual improvement and we reserve the right to make changes without notice. Trademarks All trademarks in this manual are properties of their respective owners. [. . . ] They should line up with the holes on the I/O backplate. important 16 MS-7699 Installing Memory Modules . Unlock the DIMM slot by pushing the mounting clips to the side. Vertically insert the memory module into the DIMM slot. The memory module has an off-center notch on the bottom that will only allow it to fit one way into the DIMM slot. Push the memory module deep into the DIMM slot. The plastic clips at each side of the DIMM slot will automatically close when the memory module is properly seat and an audible click should be heard. Manually check if the memory module has been locked in place by the DIMM slot’s side clips. Volt Notch Important * To ensure system stability, memory modules must be of the same type and density in Dual-Channel mode. * Always insert memory modules in the DIMM1 slot first. 17 JPWR1: ATX 24-Pin Power Connector This connector allows you to connect an ATX 24-pin power supply. To connect the ATX 24-pin power supply, align the power supply cable with the connector and firmly press the cable into the connector. If done correctly, the clip on the power cable should be hooked on the mainboard’s power connector. + 5 JPWR2: ATX 8-Pin Power Connector This connector provides 12V power to the CPU. 1 Important Make sure that all the power cables are securely connected to a proper ATX power supply to ensure stable operation of the mainboard. CPUFAN1, SYSFAN1, SYSFAN2: Fan Power Connectors The fan power connectors support system cooling fans with +12V. If the mainboard has a System Hardware Monitor chipset on-board, you must use a specially designed fan with a speed sensor to take advantage of the CPU fan control. Some system fans may not connect to the mainboard and will instead connect to the power supply directly. A system fan can be plugged into any available system fan connector. Each connector can connect to one Serial ATA device. serial ATA devices include disk drives (HD) , solid state drives (SSD) , and optical drives (CD/ DVD/ Blu-Ray). Important * Please do not fold the Serial ATA cable at a 90-degree angle. [. . . ] When set to [Auto], the CPU will operate under the default number of cores. When set to [Manual], you will be able to enable/disable the specific CPU core. Core X These items are used to enable/disable the core X. OC Genie Lite Setting this item to [Enabled] allows the system to detect the maximum FSB clock and to overclock automatically. [. . . ]