User manual MSI G52-75011X7 V1.0

[. . . ] Notice 1 The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Notice 2 Shielded interface cables and A. C. power cord, if any, must be used in order to comply with the emission limits. VOIR LA NOTICE D'INSTALLATION AVANT DE RACCORDER AU RESEAU. Micro-Star International MS-7093 This device complies with Part 15 of the FCC Rules. [. . . ] Primary/Secondary Master/Slave UDM A Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the operating environment includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus master driver). If your hard drive and your system software both support Ultra DMA/33, Ultra DMA/66 and Ultra DMA/100 select [Auto] to enable BIOS support. South OnChip PCI Device Press <Enter> to enter the sub-menu and the following screen appears: Onboard AC97 Audio [Auto] allows the mainboard to detect whether an audio device is used. If an audio device is detected, the onboard AC'97 (Audio Codec'97) controller will be enabled; if not, it is disabled. Disable the controller if you want to use other controller cards to connect an audio device. Onboard Chip SATA This setting controls the onboard SATA controller. Settings: [SATA Disabled], [IDE Controller], [RAID Controller], [Other Mass Storage]. 3-15 MS-7093 M-ATX Mainboard Super IO Device Press <Enter> to enter the sub-menu and the following screen appears: Onboard FDC Controller Select [Enabled] if your system has a floppy disk controller (FDD) installed on the system board and you wish to use it. If you install add-on FDC or the system has no floppy drive, select [Disabled] in this field. The settings are: [Enabled] and [Disabled]. Onboard Serial Port 1 Select an address and corresponding interrupt for Serial Port 1. The settings are: [3F8/IRQ4], [2E8/IRQ3], [3E8/IRQ4], [2F8/IRQ3], [Disabled], [Auto]. ACPI Suspend Type This item specifies the power saving modes for ACPI function. If your operating system supports ACPI, such as W indows 98SE, W indows ME and W indows 2000, you can choose to enter the Standby mode in S1(POS) or S3(STR) fashion through the setting of this field. Options are: S1(POS) The S1 sleep mode is a low power state. In this state, no system context is lost (CPU or chipset) and hardware maintains all system context. The S3 sleep mode is a lower power state where the in formation of system configuration and open applications/ files is saved to main memory that remains powered while most other hardware components turn off to save energy. The information stored in memory will be used to restore the system when a "wake up" event occurs. The system will decide when to enter S1 or S3 state. S3(STR) S1 & S3 Power M anagement Option This item is used to select the degree (or type) of power saving and is related to 3-18 BIOS Setup these modes: Suspend Mode and HDD Power Down. There are three options for power management: Min Saving Minimum Power Management. Suspend Mode=1 Hour Max Saving Maximum Power Management. Suspend Mode=1 Min User Define Allows end users to configure each mode separately. HDD Power Down If HDD activity is not detected for the length of time specified in this field, the hard disk drive will be powered down while all other devices remain active. [. . . ] Click Apply or OK to apply these new values. u Refer to your Windows® online help and documentation for further information on using the Settings tab. Note: Each display can use a different screen resolution. For games, it is recommended that you use the same resolution on all displays. [. . . ]