User manual MSI G52-75491XA

[. . . ] We take every care n the preparaton of ths document, but no guarantee s gven as to the correctness of ts contents. Our products are under contnual mprovement and we reserve the rght to make changes wthout notce. If a problem arses wth your system and no soluton can be obtaned from the user's manual, please contact your place of purchase or local dstrbutor. Alternatvely, please try the followng help resources for further gudance. [. . . ] You should always nstall DDR2 memory modules n the DDR2 DIMM slots. â· In Dual-Channel mode, make sure that you nstall memory modules of the same type and densty n dfferent channel DIMM slots. â· To enable successful system boot-up, always nsert the memory modules nto the DIMM1 first. The memory module has only one notch on the center and wll only fit n the rght orentaton. Then push t n untl the golden finger on the memory module s deeply nserted n the DIMM slot. The plastc clp at each sde of the DIMM slot wll automatcally close when the memory module s properly seated. Manually check f the memory module has been locked n place by the DIMM slot clps at the sdes. You can barely see the golden finger f the memory module s properly nserted n the DIMM slot. Ths connector allows you to connect an ATX 24-pn power supply. To connect the ATX 24-pn power supply, make sure the plug of the power supply s nserted n the proper orentaton and the pns are algned. Then push down the power supply firmly nto the connector. You may use the 20-pn ATX power supply as you lke. If you'd lke to use the 20-pn ATX power supply, please plug your power supply along wth pn 1 & pn 13 (refer to the mage at the rght hand). Ths power connector s used to provde power to the CPU. Make sure that all the connectors are connected to proper ATX power supples to ensure stable operaton of the manboard. To connect an LCD montor, smply plug your montor cable nto the DVI connector, and make sure that the other end of the cable s properly connected to your montor (refer to your montor manual for more nformaton. It s easy to dfferentate between audo effects accordng to the color of audo jacks. Lne-In (Blue) - Lne In, s used for external CD player, tape-player or other audo devces. If you nstall two IDE devces on the same cable, you must configure the drves separately to master / slave mode by settng jumpers. Each connector can connect to one Seral ATA devce. The fan power connectors support system coolng fan wth +12V. When connectng the wre to the connectors, always note that the red wre s the postve and should be connected to the +12V; the black wre s Ground and should be connected to GND. [. . . ] the on-lne descrpton of the hghlghted setup functon s dsplayed at the bottom of the screen. Sub-Menu If you find a rght ponter symbol appears to the left of certan fields that means a submenu can be launched from ths field. a sub-menu contans addtonal optons for a field parameter. You can use arrow keys ( ) to hghlght the field and press <Enter> to call up the sub-menu. [. . . ]