Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual MTD 1010-3. We hope that this MTD 1010-3 user guide will be useful to you.
Lastmanuals help download the user guide MTD 1010-3.
Detailed instructions for use are in the User's Guide.
[. . . ] Please follow these instructions to install the frame weights. If you have questions or problems installing or using this kit, contact your local authorized dealer or the Factory Technical Service Department.
INSTALLATION INSTRUCTIONS
1. [. . . ] If you have questions or problems installing or using this kit, contact your local authorized dealer or the Factory Technical Service Department.
INSTALLATION INSTRUCTIONS
1. Place a block beneath the transmission so that the left wheel is suspended off the ground. Remove the hairpin cotter and clevis pin that secure the wheel to the axle. Remove the screw that attaches the forward end of the transmission pan to the frame rail (Figure 1). Keep this screw in case you remove the frame weights at a later time. Front A B
WARNING
Before installing this kit, stop the engine, allow the engine to cool, disconnect the spark plug wire and move it away from the spark plug. Also align with the rear hole in the frame rail.
Description
Qty.
2 2 2 2 2 2 2 2
Frame weight. . . . . . . . . . . . . . . . . . . . . . . Flat washer, 5/16. . . . . . . . . . . . . . . . .
Frame Weight
Figure 2 Figure 4
TOOLS REQUIRED:
G G G G G 7/16" socket 3/8" wrench G 1/2" wrench 7/16" wrench G Ratchet wrench 1/2" socket A block (to support the tiller when one wheel is removed)
NOTE: There is no right or left frame weight— they are interchangeable. Put a 1/4" flat washer onto one of the 1/4-20 x 1-1/2" screws and install the screw through the front hole in the frame weight and the transmission pan (A, Figure 3). Then thread the screw into the threaded hole in the frame rail. Do not fully tighten this screw yet.
10. Reinstall the wheel and remove the block from beneath the transmission. [. . . ] Do not fully tighten this screw yet.
10. Reinstall the wheel and remove the block from beneath the transmission. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE MTD 1010-3
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual MTD 1010-3 will begin.
