User manual MTD 400132-49 PARTS LIST

[. . . ] Read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. 10 PRODUCT REFERENCES, ILLUSTRATIONS AND SPECIFICATIONS All information, illustrations, and specifications in this manual are based on the latest product information available at the time of printing. We reserve the right to make changes at any time without notice. 24 SERVICE INFORMATION Service on this unit both within and after the warranty period should be performed only by an authorized and approved service dealer. [. . . ] You must pull the starter rope out far enough to hear the engine attempt to start. There is no need to pull the rope briskly-- there is no harsh resistance when pulling. Be aware that this starting method is vastly different from (and much easier than) what you may be used to. When the engine starts, move the throttle control to the fast position ( ) and let the engine warm up for 15 to 30 seconds. The EZ-Start™ Lever will click off automatically when you move the throttle control to the fast position. The engine does not start, go back to step 3. NOTE: If you are having trouble starting the unit or are operating in extreme temperatures (below 40º F, above 90º F), refer to the Troubleshooting section. Move the throttle control to the idle position ( ). Allow the engine to cool down by idling. Put the On/Off Stop Control in the OFF (O) position. 11 OPERATING INSTRUCTIONS HOLDING THE BLOWER/VACUUM Before operating the unit, stand in the operating position. Set the blower/vacuum mode change-over lever to the up position (Blower Mode) (Fig. NOTE: Never use the unit with the lever in a position half way between either mode. Place the shoulder harness over your head, onto your shoulder and adjust it if necessary. Sweep from side to side with the nozzle several inches above the ground or floor. Slowly advance the unit, keeping the accumulated pile of debris in front of you. Most dry blowing operations are better suited to low speeds, rather than high. High speed blowing is a better way to move heavier items like large debris or gravel. 1 Use the blower for trees, shrubs, flower beds and hard-to-clean areas (Fig. Use the unit around buildings and for other normal cleaning procedures (Fig. Use the blower around walls, overhangs, fences and screens (Fig. Set the blower/vacuum mode change-over lever to the down position (Vacuum Mode) (Fig. [. . . ] The manufacturer is not liable to cover failures of warranted parts caused by the use of add-on or modified parts. € In order to file a claim, go to your nearest Authorized Troy-Bilt Service Center. warranty services or repairs will be provided at all Authorized Troy-Bilt Service Centers. € Any manufacturer approved replacement part may be used in the performance of any warranty maintenance or repair of emission related parts and will be provided without charge to the owner. [. . . ]