User manual MTD 132R

[. . . ] Note: a front windshield wiper comes standard with this cab kit. (revised: 10/23/2008) Rev. 2 of 15 NOTICE Cabs, blades, and general accessories add additional weight to the base vehicle. Deduct the accessory’s total weight from the vehicle’s rated capacity including driver and passenger. Exposure to Carbon Monoxide can Cause illness, serious injury or death. Never operate vehicle if suspicious of Carbon Monoxide. [. . . ] 4. 5 Install the hard rear panel window section to the rear legs making sure that the bent flanges on the rear legs are inside the window frame. Use the following hardware per side: three 5/16-18 x 3/4” long button head bolts, three plastic washers, six steel washers, and three locknuts. Repeat for opposite side. long bent flange and vibration mounts facing up in this photo left rear leg Fig. 4. 3 (view of hard rear panel components) 5. WINDSHIELD SUPPORT 5. 1 Per fig. 5. 1, install the windshield support to the top front corner of the side frames. Orient the windshield support so the bent flanges are down and the decals are legible. Use the following hardware in the lower hole on each side (note: the remaining holes will receive hardware when the roof is installed): one 5/16-18 x 3/4” long button head bolt, one plastic washer, two steel washers, and one locknut. Locknuts to be on the inside of the cab. Tighten these two bolts at this time. right rear leg and roll bar bracket about to be installed in its correct position Fig. 4. 3 (view from left rear side of tractor) steel washer and locknut inside Fig. 5. 1 (view from right rear side of tractor) Rev. If installing an optional hard rear panel, the back of the roof must go over the tops of the rear legs and the rear window panel so they are contained. Slide the roof as far forward as it will go. 8. 3, use the following hardware in the front corners: one 5/16-18 x 1” long button head bolt, two steel washers, one plastic washer, and one locknut (locknuts on the inside surface). Install the bolt through the roof, windshield support, and mounting tab. 8. 4 The rear corners and the middle side bolt locations use the following hardware per side: two 5/16-18 x 3/4” long button head bolts, two steel washer, and two plastic washer. These bolts are installed into factory installed threaded inserts in the top of each side frame. NOTE: use caution to avoid damaging the internal threads on the factory installed threaded inserts. 8. 5 The remaining four holes use the following hardware: four 5/16-18 x 3/4” long button head bolts, 8 steel washers, 4 plastic washers, and 4 locknuts. Note: the two middle rear bolts (see fig. 8. 5) are used for both hard or soft rear panels. When installing the standard soft rear panel, the bolts serve only as weather plugs in the existing roof holes. [. . . ] MAKE SURE DOORS ARE CLOSED AND PROPERLY LATCHED WHEN DRIVING. Fig. 14. 2 (striker bolt) EXTERIOR VIEW OF RIGHT SIDE DOOR 15. LUBRICATION 15. 1 Once the doors are properly adjusted, lubrication (preferably grease) can be applied to the striker bolts and door latch assemblies. Re-apply periodically as needed (same goes for the door pin hinges as necessary). Fig. [. . . ]