User manual MTD 2060-0

[. . . ] The green or green and yellow wire to live terminal. If your unit is for use on less than 150 volts, it has a plug as illustrated in sketch A in Figure 1 on page 2. The green-colored rigid ear, lug, or the like, must be connected to permanent ground, such as a properly grounded outlet box. no adapter is available for the plug illustrated in sketch D. [. . . ] Never use the trimmer when it is raining. Try to prevent it from getting wet or being exposed to 2 SPECIFICATIONS . When using electric gardening tools, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury, including the following. GROUNDING INSTRUCTIONS This tool should be grounded while in use to reduce the risk of electric shock to the operator. The tool is equipped with a 3-conductor cord and 3-prong grounding plug to fit the proper grounding receptacle. The green or green and yellow wire to live terminal. If your unit is for use on less than 150 volts, it has a plug as illustrated in sketch A in Figure 1 on page 2. The green-colored rigid ear, lug, or the like, must be connected to permanent ground, such as a properly grounded outlet box. no adapter is available for the plug illustrated in sketch D. EXTENSION CORDS Use only three-wire outdoor extension cords that have three-prong grounding plugs and grounding receptacles that accept the appliance’s plug. plugged-in appliance with finger on switch. A moment of inattention while operating power tools may result in serious personal injury. Do not move 1 120V Ampere Rating More than Not more than Do not force tool. The correct tools will do the job better and safer at the rate for which it is designed. Disconnect the plug from the power source before making any adjustment, changing accessories, or storing the tool. Such preventive safety measures reduce the risk of starting the tool accidentally. When not in use, tools should be stored indoors in dry, and high or locked-up lace, out of reach of children. Keep cutting tools sharp and clean for best performance and to reduce the risk of injury. Follow instructions for lubricating and changing accessories. inspect tool cord periodically , and if damaged , have it repaired by an authorized service facility. Keep handling surface dry, clean, and free from oil and grease. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. [. . . ] If you cut or damage the cord, unplug it at the electrical outlet immediately, before inspecting or repairing cord. Maintain proper footing and balance and do not overreach. Wear safety goggles, non-skid footwear and rubber gloves when trimming. Hold the tool firmly in both hands and turn the tool ON. [. . . ]