User manual MTD 210-030A

[. . . ] Read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. 7 PRODUCT REFERENCES, ILLUSTRATIONS AND SPECIFICATIONS All information, illustrations, and specifications in this manual are based on the latest product information available at the time of printing. We reserve the right to make changes at any time without notice. Inside Back Cover SERVICE INFORMATION Service on this unit both within and after the warranty period should be performed only by an authorized and approved service dealer. [. . . ] SAVE THESE INSTRUCTIONS 4 RULES FOR SAFE OPERATION SAFETY AND INTERNATIONAL SYMBOLS This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's manual for complete safety, assembly, operating and maintenance and repair information. sYMBOL MEANING • SAFETY ALERT SYMBOL Indicates danger , warning , or caution. May be used in conjunction with other symbols or pictographs. SYMBOL MEANING • THROWN OBJECTS CAN CAUSE SEVERE INJURY WARNING: Do not operate unit without proper attachments and guards in place. € WARNING - READ OPERATOR'S MANUAL Read the Operator’s Manual(s) and follow all warnings and safety instructions. Failure to do so can result in serious injury to the operator and/or bystanders. € KEEP BYSTANDERS AWAY WARNING: Keep all bystanders, especially children and pets, at least 50 feet (15 m) from the operating area. € WEAR HEAD, EYE AND HEARING PROTECTION • CHOKE CONTROL 1 • FULL choke position 2 • PARTIAL choke position 3 • RUN choke position WARNING: Thrown objects and loud noise can cause severe eye injury and hearing loss. 11989 standards and ear protection when operating this unit. Falling objects can cause severe head injury. As little as 1% water in the fuel can make fuel and oil separate. When using alcohol-blended fuel, use fresh fuel (less than 60 days old). Move the ignition switch to the Run position (Fig. Prime the carburetor by fully pressing and releasing the primer bulb 10 times (Fig. Grip the handle firmly and press the safety trigger and press/squeeze the throttle trigger to the Full Throttle position (Fig. Pull the starter rope out a short way until you feel resistance (approximately 4”). Then continue with a smooth rapid pull (for a strong spark). Pull the rope briskly in this manner 4 times (Fig. With the throttle trigger still in the Full Throttle position, pull the starter rope 4 more times. When the engine starts, leave the choke lever in Position 2 for about 10 seconds, so the unit can warm up. If engine fails to start, repeat everything from Step 2 on. [. . . ] ) *All specifications are based on the latest product information available at the time of printing. We reserve the right to make changes at any time without notice. 16 NOTES 17 MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by MTD LLC (“MTD”) with respect to new merchandise purchased and used in the United States, its possessions and territories. MTD warrants this product against defects in material and workmanship for a period of one (1) year commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. [. . . ]