User manual MTD 3010G SERVICE MANUAL

[. . . ] The manufacturer accepts no responsibility for damages resulting from unauthorised alterations to the unit that have been carried out by the owner or operator. Before commencing work with the appliance, familiarise yourself with all of the equipment and control elements as well as with their function. When working with the appliance near to public roads and when crossing the street, take care of traffic. Store fuel in appropriate containers only, and never in the vicinity of heat sources (e. g. [. . . ] Wait for one minute before the next attempt, however at the same time return the key to the /0 position. When the engine is running: n Turn the key back to /I. n Slowly turn the throttle in the direction /idle. Note Do not operate the engine when fully loaded until it is has heated up. ­ Observe the correct viscosity of the engine oil (see table in section "Servicing" and/or the engine manual). ­ Set the throttle lever into position . Setting the seat belt Fig. 13 Note If the seat belt is too long or too short to be set by pulling on the upper lying belt, the position of the readjustment clip should be changed. To do this, hold the readjustment clip tightly and pull the under lying belt through the clip. Move the clip towards the anchor point of the seat to shorten the belt or to make it longer. Set the final length of the belt with the readjustment clip , the latch and the upper lying belt into the right half of the belt. n In order to lengthen the belt, hold the readjustment clip (a) ends tightly and tip the side of the clip upwards towards the latch. The differential lock is switched off. Note Releasing the differential lock pedal does not always disengage the differential lock. You may have to reduce the tractor's speed or reverse direction (first stop the appliance) before you can disengage the differential lock. Fig. 17 n The length of the upper transverse link is normally determined by the shape of the acessory. In order to set the upper transverse link, loosen the locking lever (a) and turn the setting pipe (b). Tilt the locking lever back again if the desired length is not reached. Set correctly, the upper transverse link lies parallel or almost parallel to the lower transverse links. 18 n The length of the lower transverse link bracing at each of the lower transverse links limit the lateral movement of the lower transverse links. Loosen the counter nuts (a) and turn the hex collar (b) in order to adjust the length of the lower transverse link bracing. After setting, retighten the counter nuts. Note In order to lift an attachment using the 3 point attachment device, the engine must be running. 6 To raise the attachment (a) n Using the 3 point attachment device ;EVRMRK &IJSVI YWMRK XLI TSMRX EXXEGLQIRX HIZMGI SV YRLSSOMRK EGIWWSVMIW EP[E]W W[MXGL XLI 483 ERH XLI IRKMRI SJJ ;EMX YRXMP XLI XVEGXMZI YRMX MW FVSYKLX XS E WXERH Push the central hydraulics lever back. [. . . ] n Store the unit in a clean, dry enclosure. Information about the engine The engine manufacturer is liable for all problems related to the engine regarding performance, measuring performance, technical data, guarantee and service. You will information in the separately enclosed owner's / operator's manual provided by the manufacturer. Over-inflating reduces the longevity of the tyres. Tyre pressure should be checked before every journey. Notes concerning wheel change. ;EVRMRK 3RP] YWI ETTVSZIH ZILMGPI NEGOW Work safely. Only tighten the screws / nuts crosswise using a torque key. [. . . ]