User manual MTD 3020-0

[. . . ] Fit a shoulder bolt (D1) and nut (E1) to each of the holders (F1) and (G1) ­ Fig. Remove the 4 screws (2 on left and 2 on right) from the rear side of the chassis and use these 4 screws (A1) subsequently for the side holder attachment (Fig. Now attach the pre-assembled holders (F1 and G1) from Step 1 to the tractor using the 8 screws (A1) (Fig. Insert the bolts (B1) into the two holders and secure each bolt with a cotter pin (C1) ­ Fig. [. . . ] 3. Installing the mounting frame Figs. Fit the two plates (L1 and K1) to the plate (J1) using 4 screws (H1) and 4 nuts (I1) ­ Fig. Note: Ensure that the plates are fitted correctly. Now turn the pre-assembled mounting frame by 180° ­ see Fig. Fit the holder (C) to the pre-assembled mounting frame using 4 screws (D2) and 4 nuts (F2). Note: Ensure that correct mounting holes are used in the side retaining plates and initially tighten the nuts only handtight, as this will facilitate the subsequent installation. 5a ­ for mounting on tractors belonging to the 700 Series. 5b ­ for mounting on all other tractors. Now hook the pre-assembled mounting frame into the shoulder screws on the tractor frame/holder (Fig. Note: In the tractor series 700 first remove the retaining bolts (B1) and cotter pins (C1) from the holder (Fig. 18. Hook both grass catcher bags (G) into the tube holder, ensuring that the more impervious side (closer meshed fabric) is at the front (Fig. Note: First hook in the front side and then lower the rear side until the grass catcher bag is situated firmly in the tubular frame. Fit the rubber mount (N2) to the mower deck connector (B) using the bolt (H2), washer (I2) and safety cotter pin (J2) ­ Fig. Fit the retaining bolt (L2) and nut (M2) to the mower deck (Fig. Installing the mowed deck connector: (Figs. Open the impact guard on the mower deck and hold it firmly in this position (Fig. Place the rear upper edge of the mower deck connector over the rear upper edge of the mower deck opening. Now swivel the connector down over the mower deck opening (Fig. Note: The connector is correctly installed when the lower edge is situated over the lower edge of the mower deck opening (Fig. Ensure that the installation is correct. [. . . ] Ensure that the installation is correct. Hook the rubber mount into the retaining bolt on the mower deck to secure the mower deck connector on the mower deck (Fig. Align the guide grooves (1) on the intermediate piece (A) with the mounting lugs (2) on the mower deck connector and push the intermediate piece all the way onto the mower deck connector (Fig. Secure the intermediate piece on the mower deck connector using the retaining clips (K2) (Fig. [. . . ]