User manual MTD 3041A

[. . . ] 14 2 Operating Manual FK 105 The Front Sweeper Type FS 102/33 described below is only suitable for attachment to lawn tractors in the series 48. . /49. . /50. . and 51. . . Identification of the model number: The type plate is located under the driver's seat. The fifth and sixth positions of the model number are the series. Example: Model number l3BW506N690 = 50. . [. . . ] Never carry out assembly, testing, checking, maintenance / adjustment work etc. If an object is struck or if the front sweeper starts to make unusual vibrations: stop the engine immediately and examine the machine for damage. Contact a specialist repair shop in the case of damage. Before every use Always check the front sweeper for any damage or wear. The front sweeper must only be used when in perfect working order. Check all controls, brackets and threaded connections for damage and firm seating. Replace any damaged parts before operation. The area to be swept must previously have been cleared of large objects. can be ejected in an uncontrolled way from the sweeper under certain circumstances. 4 Operating Manual FK 105 Signs on the machine Important: Read the operating instructions before starting up. Important: Danger of injury / damage to the machine. The maximum speed of 6 km/h must not be exceeded. Keep third parties out of the danger zone. Always keep these signs on the machine in a legible condition. Maintenance Only allow maintenance work / repairs to be carried out by a specialist workshop. Before the sweeper can be coupled, the connection pieces for the MTD "Fast Attach System" must be bolted on. Match the parts to the correct side according to the illustration and attach each part using 2 bolts, 2 washers and 2 nuts. Sweeping machine Thin washer Hex. Bolt M8x25 Thick washer Lock nut M8 14. Finally, the support plates, which protect the brushes during transport and during storage in the carton against compressed areas, on the ends of the brush on the right and left must be removed. Undo the nut of the brush axle by approx. 3 turns using a ring spanner SW 19 and remove the plates. Carefully tighten the nut again afterwards. Check the tightness after 1 hour of operation. Connection piece left remove plate ___________________________________________________________________________ 9 Operating Manual FK 105 Attachment of the front sweeper 1. Place the sweeper in position in front of the lawn tractor. Turn the locking element "G" flat as shown in the picture. Hold the knob "H" with your left hand and the bracket "J" with your right hand and lift the hook ends of the connecting plates onto the bolts of the Fast-Attach-System "K". H J G K 2. In the next step, you place the V-belt on the extra pulley as shown in the picture. [. . . ] The sweeper is raised or lowered with the lifting tube "M". For raising, the bar is simply moved up and down in relation to the step using the handle until the sweeper completely engages in the "top position". For lowering, the bar is lifted at the handle. After a slight resistance, the lowering occurs slowly. M 2. For swivelling the brush deck, hold the handle of the extension tube of the swivel rod "O", lift it upwards and move it forwards or backwards in order to swivel to the left or to the right. [. . . ]