User manual MTD 310-100-088

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual MTD 310-100-088. We hope that this MTD 310-100-088 user guide will be useful to you.

Lastmanuals help download the user guide MTD 310-100-088.


Mode d'emploi MTD 310-100-088
Download
Manual abstract: user guide MTD 310-100-088

Detailed instructions for use are in the User's Guide.

[. . . ] PN 9096-320209(3) © McCulloch Corporation, 2001 • Printed in Taiwan PLEASE READ E N G L I S H The WARRANTY SYMBOL indicates that unless instructions or procedures are followed any damage caused will void the warranty and repairs will be at owner’s expense. A CAUTION may also accompany the WARRANTY SYMBOL. Service other than user maintenance should be performed by a McCulloch Authorized Service Center. Damage or conditions which render this product inoperable caused by improper maintenance practices will void the manufacturer’s warranty. [. . . ] Align the flex tube tab (A) with notch (B) in the housing (Figure 4-1A). Hearing and eye protection are required Le port de protections auditives et oculaires est nécessarie Se requiere protección para los oídos y para los ojos 4-1. FUEL Use regular grade unleaded gasoline mixed with McCulloch 40:1 custom 2-cycle engine oil for best results. 4-3B L N M E Never use straight gasoline in your unit. This will cause permanent engine damage and void the manufacturer’s warranty for that product. Never use a fuel mixture that has been stored for over 90 days. N If 2-cycle lubricant other than McCulloch Custom Lubricant is to be used, it must be a premium grade oil for 2-cycle air cooled G engines mixed at a 40:1 ratio. Do not use any 2-cycle oil product with a recommended mixing ratio of 100:1. If insufficient lubricaL I tion is the cause of engine damage, it voids the manufacturer’s engine warranty. MIXING FUEL H Add oil to an approved fuel container followed by the gasoline to allow incoming gasoline to mix with oil. INSTALLATION OF SPARK ARRESTER G A spark arrester screen is required when using your blower on U. NOTE: If engine fails to start after repeated attempts, refer to Troubleshooting section. E NOTE: Always pull starter rope straight out. pulling starter at an angle will cause rope to rub against the eyelet. This friction will N cause the rope to fray and wear more quickly. Always hold starter handle when rope retracts. Never let a rope snap back from G extended position. This could cause rope to snag or fray and also damage the starter assembly. E N G L I S H WARNING CAUTION Because of flying debris, always wear American National Standards Institute approved shielded safety glasses or face shield when operating blower. Before using your blower, review Safety Precautions in your User Manual, and all regulations for operation of the unit. These precautions and regulations are for your protection. When it is necessary to stop blower engine immediately, DEPRESS the OFF “STOP” switch (G) until the engine stops completely (Figure 6-1G). [. . . ] I Conserve water by using power blowers instead of hoses for many lawn and garden applications, including areas S such as gutters, screens, patios, grills, porches and gardens. H Watch out for children, pets, open windows or freshly washed cars, and blow debris safely away. Use the full blower nozzle extension so the air stream can work close to the ground. After using blowers and other equipment, CLEAN UP! [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE MTD 310-100-088

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual MTD 310-100-088 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag