User manual MTD 310193

[. . . ] A CAUTION may also accompany the WARRANTY SYMBOL. Service other than user maintenance should be performed by a McCulloch Authorized Service Center. Damage or conditions which render this product inoperable caused by improper maintenance practices will void the manufacturer’s warranty. Champion RDJ8J o equivalente E S P A Ñ O L 1 2 PLEASE READ E N G L I S H The WARRANTY SYMBOL indicates that unless instructions or procedures are followed any damage caused will void the warranty and repairs will be at owner’s expense. [. . . ] Remove the 2 small muffler screws (A) (Figure 4-5A). Grasp cover (B) and screen (C), and insert first screw (D) (Figure 4-5B). Install onto muffler and secure first screw. RECOMMENDED FUELS Some conventional gasolines are being blended with oxygenates such as alcohol or an ether compound to meet clean air standards. Your McCulloch engine is designed to operate satisfactorily on any gasoline intended for automotive use including oxygenated gasolines. STARTING A COLD ENGINE Fill fuel tank with proper gas and oil mixture. Set unit on ground so that it rests on housing feet. Hold trigger at fully depressed position or set throttle lock: While holding trigger (A) at wide open position, press throttle lock (B). Release trigger (A), then release throttle lock (B) (Figure 6-1A). Pump the primer bulb (C) 10 times (Figure 6-1B). Your unit is designed with a 3 position choke (D), CHOKE “ ”, START “ ”, and RUN “ ”. This friction will cause the rope to fray and wear more quickly. Always hold starter handle when rope retracts. Never let a rope snap back from extended position. This could cause rope to snag or fray and also damage the starter assembly. 7 - OPERATING INSTRUCTIONS - FONCTIONNEMENT INSTRUCCIONES DE OPERACION 7-1. BLOWER OPERATIONS (Figure 7-1A) Your McCulloch blower is designed to easily remove debris from patios, walkways, lawns, bushes, etc. , and many hard to reach areas where debris may accumulate. STARTING A WARM ENGINE (Engine has been stopped for no more than 15-20 minutes) 1. With throttle at IDLE (not depressed), pull starter rope briskly. If engine does not start, or starts and then stops after 5 rope pulls, follow procedure “6-1. Because of flying debris, always wear American National Standards Institute (A. [. . . ] If further adjustments are necessary, please take your unit to the G nearest McCulloch Authorized Service Center listed in the Yellow Pages. Turn bag INSIDE OUT and shake vigorously. This procedure should be performed on a regular basis. Turn bag RIGHT SIDE OUT, close zipper and attach to unit. [. . . ]