User manual MTD 4016

[. . . ] 2204 2205 E N G L I S H In the manual there will be the following call-outs:NOTE, WARNING / CAUTION and WARRANTY. A NOTE is used to convey additional information, to highlight a particular explanation, or expand a step description. A WARNING or CAUTION identifies a procedure which, if not undertaken or if improperly done, can result in serious personal injury or damage to the unit and/or both. The (WARRANTY SYMBOL) serves notice that unless instructions or procedures are followed, any damage caused will void the warranty and repairs will be at owner’s expense. [. . . ] Keep hair, face, fingers and loose clothing away from any openings. Do not use in the presence of flammable liquids or gases, smoking or burning materials to avoid creating a fire or explosion. Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes. Do not use in unventilated areas or where dust or explosive vapors can build up. Disconnect electrical supply before opening inlet cover or installing pick up tubes. Never operate unit without inlet cover secured or pick-up tubes in place. Do not use if the switch does not turn the appliance on and off properly. Keep everyone, especially children and pets, away from the area of operation. Never allow children to operate the appliance. Turn off unit immediately if you are approached. Always inspect the area before starting the appliance to remove debris and hard or sharp objects that can be blown or cause damage during operation. Never operate this appliance when you are tired, ill or under the influence of alcohol, drugs or medication. Voltage supply as shown on the nameplate of the appliance. Always run the appliance with the blower tubes attached to the unit. This appliance is intended for household use. E N G L I S H Remove blower from carton and examine it thoroughly to make sure it is not damaged. This electric blower requires no tools for assembly. Read your User manual carefully before assembly and operation. € VACUUM ATTACHMENT ASSEMBLY Turn off unit and unplug from electric outlet. Twist two vacuum tubes till the arrow (A) marks meet each other. Insert tube locking lugs into slots (B) in unit (Fig. [. . . ] Keep air intake clean and air vents free of debris to avoid overheating the motor. Do not squirt with a water hose or douse with water or other liquids. Abnormal vibration usually indicates a mechanical problem and continued operation could lead to injury or damage to the blower. No lubrication is necessary as the motor is equipped with lifetime lubricated bearings. [. . . ]