User manual MTD 404707

[. . . ] This operator’s manual provides you with easy-to-understand operating instructions. Read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. The parts list at the end of this manual contains all the information that you need to order parts. I. TABLE OF CONTENTS Rules for Safe Operation . 7 II. PRODUCT REFERENCES, ILLUSTRATIONS AND SPECIFICATIONS All information, illustrations and specifications in this manual are based on the latest product information available at the time of printing. [. . . ] Never remove the cap of the fuel tank, or add fuel, when the engine is hot. Never operate the unit without the fuel cap securely in place. Loosen the fuel tank cap slowly to relieve any pressure in the tank. • Mix and add fuel in a clean, well-ventilated area outdoors where there are no sparks or flames. Slowly remove the fuel cap only after stopping engine. Do not smoke while fueling or mixing fuel. Wipe up any spilled fuel from the unit immediately. • Avoid creating a source of ignition for spilled fuel. Do not start the engine until fuel vapors dissipate. RULES FOR SAFE OPERATION WHILE OPERATING • Wear safety glasses or goggles that are marked as meeting ANSI Z87. 1-1989 standards, and ear/hearing protection when operating this unit. Wear a face or dust mask if the operation is dusty. • Wear heavy, long pants, boots and gloves. These parts are available from your authorized service dealer. Do not use parts, accessories or attachments not authorized by Ryobi for this unit. Doing so could lead to serious injury to the user, or damage to the unit, and void your warranty. OTHER SAFETY WARNINGS • Allow the unit to cool before storing or transporting. Be sure to secure the unit while transporting. • Store the unit in a locked up and dry or high and dry place to prevent unauthorized use or damage, out of the reach of children. • Never douse or squirt the unit with water or any other liquid. Keep handles dry, clean and free from debris. Clean after each use, see Cleaning and Storage instructions. Refer to them often and use them to instruct other users. If you loan someone this unit, also loan them these instructions. SAVE THESE INSTRUCTIONS SAFETY AND INTERNATIONAL SYMBOLS This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's manual for complete safety, assembly, operating and maintenance and repair information. SYMBOL MEANING • SAFETY ALERT SYMBOL Indicates danger, warning, or caution. [. . . ] 9 Tighten WARNING: Verify the blade is flat against the output shaft after the nut is tightened. If the blade is off-center, the unit will be damaged by vibration, and the blade may fly off, which can cause serious personal injury. Output Shaft Hole Fig. 10 Locking Rod Locking Rod Slot Output Shaft Fig. 7 8 SPECIFICATIONS EDGER ADD-ON Unit Weight (Add-On only) . [. . . ]