User manual MTD TB320BV 41AS320G966

[. . . ] Operator’s Manual 2-Cycle Mulching Blower / Vacuum Model TB320BV SAVE THESE INSTRUCTIONS P/N 769-01308 (6/04) PRINTED IN USA DO NOT THROW AWAY INTRODUCTION THANK YOU Thank you for buying this quality product. This modern outdoor power tool will provide many hours of useful service. You will find it to be a great labor-saving device. This operator’s manual provides you with easy-tounderstand operating instructions. [. . . ] The bag may become a fire hazard when saturated with fuel. WARNING: NOTE: There is no need to turn the unit on. The On/Off Stop Control is in the ON (I) position at all times. Fully press and release the primer bulb 10 times, slowly. Some amount of fuel should be visible in the primer bulb and fuel lines (Fig. If you can’t see fuel in the bulb, press and release the bulb as many times as it takes before you can see fuel in it. Place the unit in the starting position (Fig. Move the throttle control to the idle position ( ) (Fig. This is especially important during cold starting. Push the blue EZ-Start™ Lever towards the primer bulb until it clicks and locks into place (Fig. Pull the starter rope out with a controlled and steady motion until the engine attempts to start. NOTE: The unit uses Spring Assist Starting™, which significantly reduces the effort required to start the engine. You must pull the starter rope out far enough to hear the engine attempt to start. There is no need to pull the rope briskly-- there is no harsh resistance when pulling. Be aware that this starting method is vastly different from (and much easier than) what you may be used to. When the engine starts, move the throttle control to the fast position ( ) and let the engine warm up for 15 to 30 seconds. The blue EZ-Start™ Lever will click off automatically when you move the throttle control to the fast position. The engine does not start, go back to step 2. NOTE: If you are having trouble starting the unit or are operating in extreme temperatures (below 40º F, above 90º F), refer to the Troubleshooting section. Move the throttle control to the idle position ( ). Allow the engine to cool down by idling. Put the On/Off Stop Control in the OFF (O) position. [. . . ] 21 MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purchased and used in the United States, its possessions and territories. Troy-Bilt LLC warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. This limited warranty shall only apply if this product has been operated and maintained in accordance with the Operator’s Manual furnished with the product, and has not been subject to misuse, abuse, commercial use, neglect, accident, improper maintenance, alteration, vandalism, theft, fire, water or damage because of other peril or natural disaster. Damage resulting from the installation or use of any accessory or attachment not approved by Troy-Bilt LLC for use with the product(s) covered by this manual will void your warranty as to any resulting damage. [. . . ]