User manual MTD 5010-0

[. . . ] You will find it to be a great labor-saving device. This operator’s manual provides you with easy-tounderstand operating instructions. Read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. RULES FOR SAFE OPERATION The purpose of safety symbols is to attract your attention to possible dangers. [. . . ] 1 WARNING: If chain does not off stop, turn engine and take your unit to the nearest Authorized Service Center for service. Rotate the choke lever up to the horizontal position (Fig. Pull starter rope 4-6 times, engine should start (Fig. If engine failed to start, rotate choke lever down to vertical position then repeat step 4 (Fig. The automatic choke will disengage when trigger is pulled (Fig. Using a Phillips or slotted screwdriver - turn screw 1/4 to 1/2 turn clockwise (to the right). NOTE: If chain turns while idling - turn screw back to the left until chain stops and unit continues to idle. NOTE: When starting a warm engine, go back to Step 3. Then, move the lever to Position 3 and release the throttle trigger. oTHER INSTRUCTIONS Chain Brake® Test 1. Place saw on a clear, firm, flat surface. Small trees up to 6-7 inches (15-18cm) in diameter are usually cut in a single cut. Notch cuts determine the direction the tree will fall. OPERATING INSTRUCTIONS Never walk in front of a tree that has been When bucking on a slope, always stand on the uphill side. Log supported along entire length: Cut from top (overbuck), being careful to avoid cutting into the ground (Fig. Second, cut from above (overbuck) to meet first cut and avoid pinching (Fig. Second, underbuck to meet first cut and avoid pinching (Fig. A retreat path (A) should be planned and cleared as necessary before cuts are started. The retreat path should extend back and diagonally to the rear of the expected line of fall, as illustrated in Fig. WARNING: Make the felling cut (D) from the other side of the tree and 1. 0 inches (3-5 cm) above the edge of the notch (C) (13 9). A tree on CAUTION: If fellingground, the sloping chain saw operator should keep on the uphill side of the terrain, as the tree is likely to roll or slide downhill after it is felled. [. . . ] This limited warranty shall not extend to anyone other than the original purchaser, original lessee or the person for whom it was purchased as a gift. How State Law Relates to this Warranty: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. ESTE MANUAL ES IMPORTANTE P/N 9096-31D202 (6/05) IMPRESO EN TAIWAN 22 NO LO DESECHE MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purchased and used in the United States, its possessions and territories. Troy-Bilt LLC warrants this product against defects in material and workmanship for a period of One (1) year commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. [. . . ]