User manual MTD 700G

[. . . ] Under bushes), – as well as for cutting rank weeds, shrubs and undergrowth. This unit is not permitted for any other use. The user is liable for any injury to third parties or damage to their property. Operate the unit only in the delivered technical condition as stipulated by the manufacturer. [. . . ] Damage to the D-handle or unit may occur. While holding the unit in the operating position (Fig. 7), position the D-handle to the location that provides you the best grip, and tighten the wing nut (Fig. Place the cutting attachment guard onto the shaft tube above the clamp assembly (Fig. Push the cutting attachment guard down to the top of the string head assembly and then rotate the cutting attachment guard until the screw holes align and the guard fits into the recessed pocket (Fig. It is not necessary to remove the wing nut, washer and bolt. Rotate the D-handle to place the grip above the top of the shaft housing. OIL AND FUEL RECOMMENDATIONS RECOMMENDED OIL TYPE Use high quality oil formulated for use in 2-cycle, aircooled engines. Mix the oil according to the instructions on the 2-cycle engine oil container, 40:1 (2. OIL AND FUEL MIXING INSTRUCTIONS Old and/or improperly mixed fuel are the main reasons for the unit not running properly. Be sure to use fresh, clean unleaded fuel. NOTE: Choking is not required when starting a warm engine. Start a warm engine with the ignition switch in the ON position and the choke lever in Position 2. A blade in the cutting attachment guard will cut the line to the proper length if excess line is released. For best results, tap the Bump Head on bare ground or hard soil. If line release is attempted in tall grass, the engine may stall. Some line breakage will occur from: • Normal line fatigue • Forcing the line into objects such as walls or fence posts TIPS FOR BEST TRIMMING RESULTS • Keep the cutting attachment parallel to the ground. Allow the tip of the line to do the cutting, especially along walls. Cutting with more than the tip will reduce cutting efficiency and may overload the engine. ) by working from top to bottom in small increments to avoid premature line wear or engine drag. € Cut from left to right whenever possible. Cutting to the right improves the unit's cutting efficiency. [. . . ] CLEANING Use a small brush to clean off the outside of the unit. Household cleaners that contain aromatic oils such as pine and lemon, and solvents such as kerosene, can damage plastic housing or handle. Wipe off any moisture with a soft cloth. STORAGE • Never store the unit with fuel in the tank where fumes may reach an open flame or spark. [. . . ]