User manual MTD 7011

[. . . ] Before starting or operating this equipment, read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. All information, illustrations and specifications in this manual are based on the latest product information available at the time of printing. We reserve the right to make changes at any time without notice. Service on this unit both within and after the warranty period should be performed only by a Cub Cadet dealer. [. . . ] Release your hand from the throttle control (Fig. Allow the engine to cool down by idling. Put the On/Off Stop Control in the OFF (O) position (Fig. Operate this unit only in a well-ventilated outdoor area. Make sure you are in the starting position when pulling the starter rope (Fig. To avoid serious injury, the operator and unit must be in a stable position while starting. 9 Operation (continued) Each time the head is bumped, about 1 inch (25. A blade in the cutting attachment shield will cut the line to the proper length if any excess line is released. For best results, tap the bump knob on bare ground or hard soil. If you attempt a line release in tall grass, the engine may stall. Always keep the trimming line fully extended. € Trim only when grass and weeds are dry. € The life of your cutting line is dependent upon: • Following the trimming techniques • What vegetation is being cut • Where vegetation is cut For example, the line will wear faster when trimming against a foundation wall as opposed to trimming around a tree. decorative Trimming Decorative trimming is accomplished by removing all vegetation around trees , posts , fences and more. Rotate the whole unit so that the cutting attachment is at a 30° angle to the ground (Fig. 10 Section 6 Maintenance Maintenance Schedule Perform these required maintenance procedures at the frequency stated in the table. These procedures should also be a part of any seasonal tune-up. NOTE: Some maintenance procedures may require special tools or skills. If you are unsure about these procedures take your unit to any nonroad engine repair establishment. NOTE: Maintenance, replacement or repair of the emission control devices and system may be performed by any non-road engine repair establishment, individual or authorized service dealer. In order to assure peak performance of your engine, inspection of the engine exhaust port may be necessary after 50 hours of operation. If you notice lost RPM, poor performance or general lack of acceleration, this service may be required. [. . . ] The manufacturer is not liable to cover failures of warranted parts caused by the use of add-on or modified parts. € In order to file a claim, go to your nearest Authorized Cub Cadet Service Center. warranty services or repairs will be provided at all Authorized Cub Cadet Service Centers. € Any manufacturer approved replacement part may be used in the performance of any warranty maintenance or repair of emission related parts and will be provided without charge to the owner. [. . . ]