User manual MTD 9016

[. . . ] In order to make the best use of your investment, be CERTAIN to familiarize yourself with the contents of the ENTIRE User Manual before attempting to operate and maintain your unit. Be sure to carefully follow the step-by-step illustrations in this manual to start, operate and maintain your new product. 9kg) E N G L I S H In the manual there will be the following call-outs: NOTE, WARNING / CAUTION and WARRANTY. A NOTE is used to convey additional information, to highlight a particular explanation, or expand a step description. [. . . ] A WARNING identifies a procedure which, if not undertaken or if improperly done, can result in a serious personal S injury or damage to the unit and/or both. (WARRANTY SYMBOL) serves notice that unless instructions or procedures are followed, any damage will void the warranty and repairs will be at owner’s expense. Service other than user maintenance should be performed by a McCulloch Authorized Service Center. Damage or conditions caused BY improper maintenance practices which render this product inoperable will void the manufacturer’s warranty. FOR WARRANTY OR SERVICE contact the nearest McCulloch Authorized Service Center listed under “SAWS” in your telephone directory Yellow Pages. For service information, contact the McCulloch Product Service Department listed on the back cover of this User Manual. RISK OF EYE INJURY - Always wear goggles or other suitable eye protection when operating your trimmer. Edging increases the risk of injury caused by flying debris. Always keep bystanders at a safe distance. kEEP HANDS AND FEET AWAY from rotating line. DRESS PROPERLY - Always wear long pants, shoes and gloves. The cut-off knife in the debris shield will trim off excess line. To switch off the string trimmer let go of the switch. I S H A short or worn wire cuts less efficiently so, to improve its operation on subsequent occasions, bump the spool button lightly on the ground while the trimmer is running. (Fig 4-4B) These operations should be repeated a few times before starting work to make sure that everything is functioning properly and to familiarize yourself with the string trimmer. Start off slowly, when you have gained experience, you will be able to use the grass trimmer to its full potential. Push shaft release button (A) and move motor housing forward or backward to desired length. Push edge button (B) and rotate handle assembly until an audible click is heard. ADJUST THE ASSIST HANDLE NOTE: The assist handle is attached to the shaft but has been turned under for packing 1. When starting the string-trimmer for the first time, check that the nylon line touch or pass over the wire-cutting blade. If they are not long enough, press the bump knob and, at the same time, pull the nylon line. Make sure the length of grass trimmer and position of assist handle is most applicable before use, adjust the length of grass trimmer by pressing the shaft adjustment button, adjust the height of assist handle by loosening the adjustment knob. [. . . ] Start the grass trimmer following the instructions in the “STARTING” section. MAINTENANCE CAUTION Before carrying out any maintenance operations, cut off the electric power supply by disconnecting the plug from the extension cable. Insérez le fil dans chaque orifice du support de bobine, et faites glisser la bobine dans ce support (Fig. Remove the spool assembly from the trimmer. [. . . ]