User manual MTD A1032K

[. . . ] In order to make the best use of your investment, be CERTAIN to familiarize yourself with the contents of the ENTIRE User Manual before attempting to operate and maintain your unit. Be sure to carefully follow the step-by-step illustrations in this manual to start, operate and maintain your new product. 1 - GENERAL INFORMATION - GENERALITES INFORMACION GENERAL E N G L I S H SPECIFICATIONS 2026 2027 E N G L I S H In the manual there will be the following call-outs: NOTE, WARNING /CAUTION and WARRANTY. A NOTE is used to convey additional information, to highlight a particular explanation, or expand a step description. [. . . ] Do not use any type of wire or metal cutting line. AVOID UNINTENTIONAL STARTING - Do not carry plugged in trimmer with your finger on the switch. DISCONNECT trimmer from power supply when not in use and before servicing stringhead. Appliance should be stored in a dry, high or locked up place - out of the reach of children. A NOTE is used to convey additional information, or highlight a particular explanation, or to expand a step instruction. A WARNING identifies a procedure which, if not undertaken or if improperly done, can result in a serious personal injury or damage to the unit and/or both. For service information, contact the McCulloch Product Service Department listed on the back cover of this User Manual. RISK OF EYE INJURY - Always wear goggles or other suitable eye protection when operating your trimmer. Edging increases the risk of injury caused by flying debris. Always keep bystanders at a safe distance. kEEP HANDS AND FEET AWAY from rotating line. FOR WARRANTY OR SERVICE contact the nearest McCulloch Authorized Service Center listed under “SAWS” in your telephone directory Yellow Pages. 2- INTERNATIONAL SYMBOLS - SYMBOLES INTERNATIONAUX SIMBOLOS INTERNACIONALES Use of these personal safety items is highly recommended to reduce the risk of accidental injury. 3-1B CONSERVE ESTAS INSTRUCCIONES NOTE: The only assembly required for your trimmer is to install the debris shield and adjust the assist handle. Position the motor housing with stringhead carrier facing up (Figure 3-1A). Push shaft locking button forward, and rotate handle assembly until an audible click is heard (Fig. When starting the string-trimmer for the first time, check that the nylon wires touch or pass over the wire-cutting blade. If they are not long enough, press the button and, at the same time, pull the nylon wires (Fig. Connect the plug of the string-trimmer to the extension cord and attach to the handle. Remove cutter knife (A) from debris shield (B). Sharpen knife using a flat file, being careful to maintain the angle of cutting edge. Insert the handle in comfortable position and tighten securely. [. . . ] Once this has been removed, extract the finished spool, clean the inside of the spool carrier and the cover carefully, making sure not to lose the spring. Insert this into position in the spool carrier. Take the new replacement spool (3), insert the ends of the wires into the holes on the cover, put the spool into position , keeping the side with the label facing upward. Fit everything into the spool carrier by pressing down and rotating clockwise until locking. [. . . ]