User manual MTD F5

[. . . ] This operator’s manual provides you with easy-tounderstand operating instructions. Read the entire manual and follow all of the instructions to keep your new outdoor power tool in top operating condition. The other manual that came with your power tool, the parts manual, contains all of the information that you need to order parts. II. TABLE OF CONTENTS California Emission Regulations . [. . . ] PLACE THE CHOKE LEVER IN THE “START” POSITION (A) (Fig. WITH THE UNIT ON THE GROUND, SQUEEZE THE THROTTLE TRIGGER FULLY AND PULL THE STARTER ROPE BRISKLY (Fig. 7) until the engine sounds like it wants to run (normally 2 to 5 pulls). NOTE: Keep the throttle trigger depressed at all times until the engine is warmed up. PLACE THE CHOKE LEVER IN THE “RUN” POSITION (B) (Fig. PULL THE STARTER ROPE BRISKLY 1 TO 3 TIMES TO START THE ENGINE (Fig. If the engine does not start, repeat steps 4 through 7. NOTE: If the engine floods while attempting to start the unit, place the choke lever in the “RUN” position (B), squeeze the throttle trigger, and pull the starter rope briskly. The engine should start within three (3) to eight (8) pulls. Keep throttle trigger depressed for 5 to 10 seconds to warm up engine. NOTE: Choking is not required when starting a warm engine. Use line with a diameter of 0. 080 in (2. 03 mm). The motor may overheat and fail if you use a larger line. WINDING THE EXISTING INNER REEL WITH NEW LINE NOTE: Before installing new trimming line onto the existing inner reel, remove any old line from the SpeedSpool by pulling the line out of the line loading or locking holes (Figs. Line up the arrow on the inner reel with the arrow on the outer spool (Fig. WARNING: Always use the correct line length when installing trimming line on the unit. If longer line is used than specified in this manual, the line may not release properly. TOP VIEW OF THE SPEEDSPOOL Outer Spool Arrow 2. Insert 10 feet (2. 5 m) of . 080 in (2. 03 mm) trimming line into one of the two eyelets and push it up through the line loading hole in the inner reel (Fig. Do not bend the line when inserting it into the eyelet. Trimming Line Eyelet Line Loading Hole Fig. Insert the line into the locking hole (Fig. [. . . ] Any replacement part that is equivalent in performance or durability may be used in non-warranty maintenance or repair and will not reduce the warranty obligations of the manufacturer. The following components are included in the emission related warranty of the engine, air filter, carburetor, primer, fuel lines, fuel pick up/fuel filter, ignition module, spark plug and muffler. • • • • • • • • • • • 19 LIMITED TWO-YEAR WARRANTY RYOBI OUTDOOR PRODUCTS warrants each new RYOBI Product for two (2) years according to the following terms. This warranty extends to the original retail purchaser only and commences on the date of original retail purchase. Any part of the RYOBI Product manufactured or supplied by RYOBI and found in the reasonable judgement of RYOBI to be defective in material or workmanship will be repaired or replaced by an authorized RYOBI service dealer without charge for parts and labor. [. . . ]