User manual MTD LGT1610 ASSEMBLY

[. . . ] Read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. 11 PRODUCT REFERENCES, ILLUSTRATIONS AND SPECIFICATIONS All information, illustrations, and specifications in this manual are based on the latest product information available at the time of printing. We reserve the right to make changes at any time without notice. 23 SERVICE INFORMATION Service on this unit both within and after the warranty period should be performed only by an authorized and approved service dealer. [. . . ] Make sure that any Add-On item is installed correctly and secure before starting the unit. NOTE: There is no need to turn the unit on. The On/Off Stop Control is in the ON ( I ) position at all times. Fully press and release the primer bulb 10 times, slowly. Some amount of fuel should be visible in the primer bulb and fuel lines (Fig. If you can’t see fuel in the bulb, press and release the bulb as many times as it takes before you can see fuel in it. Push the blue EZ-Start™ Lever towards the primer bulb until it clicks and locks into place (Fig. Crouch in the starting position and do not squeeze the throttle control (Fig. Pull the starter rope up to 10 times briskly, until the engine starts. When the engine starts, squeeze the throttle lock-out and then squeeze the throttle control for 15 to 30 seconds. The blue EZ-Start™ Lever will click off automatically when you squeeze the throttle control. Check for the following: • The operator is wearing eye protection and proper clothing • With a slightly-bent right arm, the operator’s right hand is holding the shaft grip • The operator’s left arm is straight, the left hand holding the J-handle • The unit is at waist level • The cutting attachment is parallel to the ground and easily contacts the grass without the need to bend over Once you are in the operating position, hook the shoulder strap to the unit. Each time the head is bumped, about 1 inch (25. A blade in the cutting attachment shield will cut the line to the proper length if excess line is released. For best results, tap the Bump Head™ on bare ground or hard soil. If line release is attempted in tall grass, the engine may stall. Always keep the trimming line fully extended. Line release becomes more difficult as the cutting line becomes shorter. NOTE: Do not rest the Bump Head™ on the ground while the unit is running. Or alter CAUTION: Do not remove blade the line cutting assembly. Excessive line length will make the clutch overheat. This may lead to serious personal injury or damage to the unit. [. . . ] € Any manufacturer approved replacement part may be used in the performance of any warranty maintenance or repair of emission related parts and will be provided without charge to the owner. Any replacement part that is equivalent in performance or durability may be used in non-warranty maintenance or repair and will not reduce the warranty obligations of the manufacturer • The following components are included in the emission related warranty of the engine, air filter, carburetor, primer, fuel lines, fuel pick up/ fuel filter, ignition module, spark plug and muffler. 25 MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by MTD LLC (“MTD”) with respect to new merchandise purchased and used in the United States, its possessions and territories. MTD warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. [. . . ]