User manual MTD TB465SS

[. . . ] Operator’s Manual 4-Cycle Gasoline Trimmer Model TB415CS & Model TB465SS SAVE THESE INSTRUCTIONS For service call 1-800-520-5520 to obtain a list of authorized service dealers near you. For more details about your unit, visit our website at www. Service on this unit both within and after the warranty period should be performed only by an authorized and approved service dealer. Forest Land and in the states of California, Maine, Oregon and Washington. [. . . ] Lines other than those specified may make the engine overheat or fail. Insert each end of the replacement line into the holes on either side of retention hook (Fig. Push the ends through until they stick out of the sides of the head (Fig. Pull the ends through making sure that the ends are of equal length and the middle of the line is centered between the insertion holes (Fig. If the ends are not of equal length, push the longer end back through the head part way and pull the shorter end to compensate. Repeat until both ends are the same length. Push the trimmer line behind the hook to secure it from coming loose while running (Fig. 12 WARNING: Always use the correct line length when installing trimming line on the unit. 6 MAINTENANCE AND REPAIR INSTRUCTIONS MAINTENANCE SCHEDULE Perform these required maintenance procedures at the frequency stated in the table. These procedures should also be a part of any seasonal tune-up. NOTE: Some maintenance procedures may require special tools or skills. If you are unsure about these procedures take your unit to any non-road engine repair establishment, individual or authorized service dealer. NOTE: Maintenance, replacement, or repair of the emission control devices and system may be performed by any non-road engine repair establishment, individual or authorized service dealer. From inside the cutting attachment shield, push the square bolt through the hole until the threaded end protrudes through the guard mounting bracket (Fig. Put the washer on the bolt, then screw the wing nut onto the bolt and tighten. CHECKING THE OIL LEVEL The importance of checking and maintaining the proper oil level in the crankcase cannot be overemphasized. Stop the engine and allow oil to drain into the crankcase. CAUTION: To prevent extensive engine wear and damage to the unit, always maintain the proper oil level in the crankcase. Never operate the unit with the oil level below the bottom of the dipstick. Place the unit on a flat, level surface to get a proper oil level reading. Keep dirt, grass clippings and other debris out of the engine. Clean the area around the oil fill plug/dipstick before removing it. [. . . ] Troy-Bilt LLC warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. This limited warranty shall only apply if this product has been operated and maintained in accordance with the Operator’s Manual furnished with the product, and has not been subject to misuse, abuse, commercial use, neglect, accident, improper maintenance, alteration, vandalism, theft, fire, water or damage because of other peril or natural disaster. Damage resulting from the installation or use of any accessory or attachment not approved by TroyBilt LLC for use with the product(s) covered by this manual will void your warranty as to any resulting damage. This warranty is limited to ninety (90) days from the date of original retail purchase for any Troy-Bilt product that is used for rental or commercial purposes, or any other income-producing purpose. [. . . ]