User manual MTD TB5020CC

[. . . ] Hold chain saw firmly with both hands when using. For your own safety, please read and follow the safety precautions in this manual before attempting to operate your chain saw. SAVE THESE INSTRUCTIONS P/N 9096-31D202 (6/05) PRINTED IN TAIWAN DO NOT THROW AWAY INTRODUCTION THANK YOU Thank you for buying this quality product. This modern outdoor power tool will provide many hours of useful service. [. . . ] Then, move the lever to Position 3 and release the throttle trigger. oTHER INSTRUCTIONS Chain Brake® Test 1. Place saw on a clear, firm, flat surface. Grasp the rear handle (A) with your right hand (Fig. With your left hand, hold the front handle (B) [not Chain Brake® lever (C)] firmly (Fig. Squeeze the throttle trigger to 1/3 throttle, then immediately activate the Chain Brake® lever (C) (Fig. When it does, immediately release the throttle/trigger. If Chain Brake® functions properly, turn the engine off and return the Chain Brake® to the DISENGAGED position. Release the trigger and allow the engine to return to the idle speed. Move the STOP switch to the STOP position. NOTE: For emergency stopping, simply activate the Chain Brake® and move the STOP switch down. NOTE: This unit will not run with the choke lever in horizontal Position 1. NOTE: The unit uses Spring Assist Starting™, which significantly reduces the effort required to start the engine. You must pull the starter rope out far enough to hear the engine attempt to start. There is no need to pull the rope briskly-- there is no harsh resistance when pulling. Be aware that this starting method is vastly different from (and much easier than) what you may be used to. 3 L Chain Lubrication Adequate lubrication of the saw chain is essential at all times to minimize friction with the guide bar. Running the saw with too little oil will decrease cutting efficiency, shorten saw chain life, cause rapid dulling of chain, and cause excessive wear of bar from overheating. Too little oil is evidenced by smoke, bar discoloration or pitch build-up. 8 Automatic Oiler Your chain saw is equipped with an automatic gear driven oiler system. The oiler automatically delivers the proper amount of oil to the bar and chain. As the engine speed increases, so does the oil flow to the bar pad. [. . . ] This limited warranty shall only apply if this product has been operated and maintained in accordance with the Operator’s Manual furnished with the product, and has not been subject to misuse, abuse, commercial use, neglect, accident, improper maintenance, alteration, vandalism, theft, fire, water or damage because of other peril or natural disaster. Damage resulting from the installation or use of any accessory or attachment not approved by Troy-Bilt LLC for use with the product(s) covered by this manual will void your warranty as to any resulting damage. This warranty is limited to ninety (90) days from the date of original retail purchase for any Troy-Bilt product that is used for rental or commercial purposes, or any other income-producing purpose. hOW TO OBTAIN SERVICE: Warranty service is available , WITH PROOF OF PURCHASE THROUGH YOUR LOCAL AUTHORIZED SERVICE DEALER. [. . . ]