User manual MTD U0504

[. . . ] This operator’s manual provides you with easy-to-understand operating instructions. Read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. PRODUCT REFERENCES, ILLUSTRATIONS AND SPECIFICATIONS All information, illustrations and specifications in this manual are based on the latest product information available at the time of printing. We reserve the right to make changes at any time without notice. Copyright© 2000 MTD Southwest Inc All Rights Reserved. Table of Contents Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] See Figure 4-1 for specific gas and oil mixing ratios. NOTE: One gallon (3. 8 liters) of unleaded gasoline mixed with one 4 oz. (118 ml) bottle of TROY-BILT 2-CYCLE OIL makes a 32:1 fuel/oil ratio. MIXING RATIO - 32:1 Fig. 4-1 Oil and Gas Mixing Instructions Old and/or improperly mixed fuel are the main reasons for the unit not running properly. Be sure to use fresh, clean unleaded fuel. Follow the instructions carefully for the proper fuel/oil mixture. Definition of Blended Fuels Today's fuels are often a blend of gasoline and oxygenates such as ethanol, methanol or MTBE (ether). As little as 1% water in the fuel can make fuel and oil separate. When using alcohol-blended fuel, use fresh fuel (less than 60 days old). Using Blended Fuels If you choose to use a blended fuel, or its use is unavoidable, follow recommended precautions. • Always use fresh fuel mix per your operator's manual. NOTE: If the engine floods while trying to start, place the choke lever in the RUN (B) position. The engine should start within three (3) to eight (8) pulls. Squeeze the throttle control to warm up engine for 5 to 10 seconds. Place the choke lever in the RUN (B) position (Fig. NOTE: Choking is unnecessary when starting a warm engine. Put the On/Off Stop Control in the START (I) position (Fig. 5-1), and the choke lever in the RUN (B) position (Fig. 5-3 Throttle Control STOPPING INSTRUCTIONS STARTING INSTRUCTIONS 1. Release your hand from the throttle control (Fig. To stop the engine, put the On/Off Stop Control in the STOP [O] position (Fig. 5-1). Operate this unit only in a well ventilated area outdoors. [. . . ] AFS™ Dual String Cutting Head Line Spool . Automatic Line Feed Releaser Line Spool Diameter . 3 inches (76. 2 mm) Trimming Line Diameter . 0. 080 inches (2. 03 mm) Cutting Path Diameter . [. . . ]