User manual MTD Z18

[. . . ] The recognition rate may vary depending on the user’s characteristics (voice, pronunciation, intonation, and speed) and the environment (noise and TV volume). Used for viewing 3D video. /Q. MENU /Q. MENU Accesses the Universal Control Menu. Accesses the quick menu. /Q. MENU /Q. MENU MUTE Mutes all sounds. VOL/ (+/-) Adjusts the volume level. [. . . ] CH/P(∧/∨) Scrolls through the saved channels. /Q. MENU * Image shown may differ from your product. * If the TV you purchased does not support 3D, the 3D button has no function. - Non 3D models: LN**, PN**, MS53*, MS73* Installing Batteries ꔛ Please ꔛ read this manual carefully and use the TV correctly. Press the end of the battery cover, slide it back and lift the cover as shown below. ꔛ To replace batteries, open the battery cover, replace Alkaline batteries (1. 5 V AA) matching and ends to the label inside the compartment, and close the battery cover. Be sure to point the remote control at the remote control sensor on the TV. ꔛ To remove the batteries, perform the installation actions in reverse. Don’t mix old or used batteries with new ones. 3 Attach the RF Dongle to the velcro as shown above and then turn on the TV. Now, register the Magic Remote Control with your TV. * If the RF Dongle for the wireless media box is attached, attach the RF Dongle for the Magic Remote Control on the below right of the back of the TV. 4 REGISTERING To use the Magic Remote Control, pair it with your TV first. HOW TO USE How to register the Magic Remote Control 1  ut batteries into the Magic Remote P Control and turn the TV on. 2  oint the Magic Remote Control at P your TV and press the WHEEL (OK) on the remote control. * f the TV fails to register the Magic I Remote Control, try again after turning the TV off and back on. How to Re-register the Magic Remote Control Press the BACK and SMART at the same time, for five seconds, to unpair the Magic Remote Control with your TV. If you wish to re-register the remote, /Q. MENU press the WHEEL (OK) on the remote control. *  hake the Magic Remote Control slightly to the right S and left or press SMART , , /Q. MENU buttons to make the pointer appear on the screen. *  hake the Magic Remote Control slightly to the right S and left to make the pointer appear on the center of screen. * f the pointer has not been used for a certain period of I time, it will disappear. [. . . ] *  hake the Magic Remote Control slightly to the right S and left to make the pointer appear on the center of screen. * f the pointer has not been used for a certain period of I time, it will disappear. *  he wheel also functions as the ‘OK’ button when T pressed. [. . . ]