User manual MTD ZYJ1388A

[. . . ] This symbol refers to a hazard or unsafe practice which can result in personal injury or product or property damage. Fm Page 3 Tuesday, February 12, 2013 2:53 PM INSTALLATION LOCATION • We recommend that this air conditioner be installed properly by qualified installation technicians in accordance with the Installation Instructions provided with the unit. € Before installation, check that the voltage of the electric supply in your home or office is the same as the voltage shown on the nameplate. € • Do not install this air conditioner where there are fumes or flammable gases, or in an extremely humid space such as a greenhouse. [. . . ] STRONG MEDIUM WEAK (Swing/Air direction) button Push the Swing/Airflow direction button to set the auto swing or air direction to a specific angle. Push the Temperature Setting buttons to change the desired temperature setting. Group Control Group control function is suitable for operating the multiple air conditioners in a large single room. Operation of all indoor units in the same mode except for airflow direction. Fm Page 9 Tuesday, February 12, 2013 2:53 PM ADJUSTING AIRFLOW DIRECTION The functions differ depending on the indoor unit used. The airflow direction cannot be set using the remote controller for any unit which is not listed below. Y2 type, K2 type: • • • Never use your hands to move the flap (vertical airflow flap) that is controlled using the remote controller. When the air conditioner is turned off, the flap (vertical airflow flap) automatically moves to the downward position. The flap (vertical airflow flap) moves to the upward position when performing the standby operation for heating. The swing operation is made after the standby operation for heating is released, but swing is indicated on the remote controller even during the standby operation for heating. fLAP button is pressed during operation. (This interval will vary slightly depending upon the outdoor temperature and the way in which frost forms. ) For several minutes after the start of heating operation, the indoor fan will not start running (or it will run at very low speed in some cases) until the indoor heat exchanger coil has warmed up sufficiently. This is because a cold draft prevention system is operating. During this period, the ‘‘ ’’ (standby) indicator remains displayed. €‘ ’’ (standby) remains displayed during defrosting or when the compressor has been turned off (or when the unit is running at very low speed) by the thermostat when the system is in the heating mode. Upon completion of defrosting and when the compressor is turned on again, ‘‘ ’’ (standby) will turn off automatically as heating operation resumes. Defrosting • (standby) on the display • • • NOTE Should the power fail while the unit is running If the power supply for this unit is temporarily cut off, the unit will automatically resume operation (once the power is restored) using the same settings before the power was cut off. For safety, be sure to turn the air conditioner off and also to disconnect the power before cleaning. Do not pour water on the indoor unit to clean it. This will damage the internal components and cause an electric shock hazard. Never use solvents or harsh chemicals when cleaning the indoor unit. [. . . ] To prevent conditioned air from escaping, keep windows, doors and any other openings closed. NOTE Should the power fail while the unit is running If the power supply for this unit is temporarily cut off, the unit will automatically resume operation once power is restored using the same settings before the power was interrupted. (Type sans fil : pour commander n’importe quel type de l’unité intérieure) 21 02_F569003_FR. Fm Page 22 Wednesday, February 13, 2013 4:40 PM Télécommande de minuterie (pièces en option) (Type avec fil : pour commander n’importe quel type de l’unité intérieure) REMARQUE Pour en savoir plus, consultez le mode d’emploi accompagnant la télécommande de minuterie en option. [. . . ]