User manual MULHOLLAND OMNI 1&2

[. . . ] TM Use r s Manual 1 TABLE OF CONTENTS Preface Design Goals Precautions Components Assembly Adjustment Overview Fitting Instructions Main Column Adjustment Tray Adjustment Knee Block Adjustment Foot Support Adjustment Optional Configurations Prone Stander Supine Stander Neckrest Support System (Prone) Shoulder Pad Assembly Placing the Child in the Stander Maintenance Technical Data 3 3 3 4-5 6-11 12 13 14-15 16 17 18 19-25 19 20-21 22-23 24-25 26 26 27 2 PREFACE This booklet provides information for the set up and use of the OMNITM. Supported standing can stimulate head-righting, weight-bearing on the forearms, and mid-line hand use. Standing also provides an opportunity for peer socialization and interaction, and upper extremity activities, which should be an integral part of a standing program. DESIGN GOALS The OMNITM was designed to provide individuals requiring prone, vertical, or supine standing, precise postural control at the upper trunk, pelvis, knees, and ankles. Adjustment from prone to vertical to supine offers therapists the opportunity to provide graduated weight-bearing to promote more normal tone distribution and stability, and selective extension of the spine. PRECAUTIONS 1. [. . . ] If more height is required loosen the column adjustment lever (3) and extend the upper column. Measure from the foot support plate to the top of the hip support (Adj. Adjust the hip support to the correct height (measurement 1). Loosen the two hip support adjustment levers (4). Slide the hip support along the upper column. Hip and Trunk Support Width: (You may need to loosen the straps to increase the width) Slightly loosen the adjustment levers (2, 4) making sure the height of the hip and trunk supports do not change. Slide the bars to the appropriate width (measurements 4&5). It is very important to make sure that the outside of the bars are an equal distance from the mid-line of the column. If they are not, the child may not be weight bearing evenly. Tighten the levers and velcro the inside strap. The straps will be adjusted by the velcro later as part of the fine tuning while the child is in the stander. Complete this adjustment for both the upper and lower supports. Pitch: Remove the ball lock pin on the tilt mechanism (Adj. Hold the column assembly and step down on the peddle. Tilt the column to the desired angle then release the peddle. Replace the ball lock pin. 14 Figure 15 2 ADJ. 1 1 15 TRAY ADJUSTMENT Refer to figure 16. Height: Loosen the two allen screws (1) and slide the tray along the upper column to the desired height. Depth: Loosen the two knobs (2), located underneath the tray. Slide the tray along the tray bar to the desired depth. Rotate the tray about the tray mounting bar to the desired angle. Make sure the teeth on the angle locks mesh. [. . . ] Tighten the allen screw (6) to tighten the bar clamp. Width: Loosen the set screw (11) 24 2 1 4 2 Figure 32 7 10 5 3 12 8 6 11 Figure 33 on the bottom of the pivot pin receiver. Slide the receiver along the hex bar (12) to the desired width. Pivoting the shoulder pads: The shoulder pads can be released and pivoted out of the way while placing the child in or removing the child from the stander. [. . . ]