User manual MULTICOAT MULTI-TEX STUCCO

[. . . ] Substrates should be constructed in compliance with all applicable building codes. Plywood substrates, including tongue and groove plywood, must be 5/8" minimum thickness, exterior grade CC PTS plywood, 16" maximum support spacing, edges blocked, all fastened with 8 penny ring shank nails or equivalent, on maximum 6" centers. (NOTE: Plywood must be nailed on all four sides. ) Moisture content should be below 15%. [. . . ] CONCRETE SUBSTRATE Open cracks with a crack chaser to 1/4" and clean out dust and residue. Cracks and all holes, voids, etc. , must be filled with suitable filling material. See "CRACK REPAIR SYSTEM" and "MULTIPATCH SYSTEM"for details. KRETE KOTE - SECOND COAT - TROWELED COVER FIBERGLASS COMPLETELY. APPLY TEXTURE COAT AND COLORSEAL. APPLICATION Coat all plywood joints, flashings, posts, drains, coves, stairwells and other irregularities with MULASTICOAT; embed with Stitchbonded Polyester Fabric; apply additional MULASTICOAT to saturate fabric, and allow to dry. MULASTICOAT is then applied over entire substrate in two (2) coats with roller, using firm pressure. (See "COVERAGE" below. ) First coat is allowed to dry to touch, usually 1-2 hours depending on ambient temperature. Second coat is applied crisscross to first coat. Allow MULASTICOAT to fully dry before proceeding with KRETE KOTE/TOP COAT 2000 surfacing. DO NOT ALLOW MULASTICOAT TO BE EXPOSED FOR MORE THAN 3 DAYS. Stitchbonded Plyester Fabric - 10" wide rolls x 324 ft. Shelf life is approximately 24 months in unopened bags and approximately 18 months in unopened pails. WARRANTY Materials are guaranteed with respect to uniformity and quality within manufacturers' specifications. Seller makes no other warranty, expressed or implied, regarding the use of its products. Since use of the product is beyond Seller's control, the Buyer assumes all risks of use. Seller's sole obligation shall be to replace material if found to be defective. Seller shall not be liable for any damages, injury, loss, direct or consequential, resulting from use of its products. COLORSEAL (Recommended) Apply two coats of COLORSEAL (Refer to COLORSEAL TEST DATA-- SLATEX SYSTEM (Above Grade) TEST METHOD RESULTS 1. ASTM A756D & E 25 Cycles Passed CONCRETE 3. ASTM A756D & E 89 psi 218 psi Plywood Mulasticoat Failure at: . [. . . ] ASTM D-1242A 1000Rev - 1000Gm Load 39 mil Loss No Loss 5. 2" Dia x 48" Water head for 48 Hrs 6. ASTM D2299 To most Chemicals and Solvents 8. [. . . ]